User manual AMERICAN AUDIO TTD-2500

[. . . ] Headshell Speed Select Buttons Pitch Adjustment (+/-10%) Pitch Control Slider Tonearm Anti-skate Knob Counterweight Spare phono cartridge slot Hinge for dust cover Trim control for changing the range of the pitch adjustment (11, 12). Right RCA output jack (red) Left RCA output jack (white) Ground (GND) Remote Start/Stop 1/4" output jack Beat output for Beat Analyser 19 20 21 23 22 9. 23. Before Use Check for the following parts included in the package with the main unit. · Turntable Platter · Slip mat · Dust Cover · 45-rpm adapter · Counterweight · Headshell · User instructions NOTES: · Do not connect the AC power plug before assembly has been completed. [. . . ] (f) Hold the counterweight stationary with one hand and rotate only the stylus-pressure ring to bring the number "o" of the ring into alignment with he center line on the tonearm rear shaft. (g) Rotate the counterweight counterclockwise until the scale shows the value corresponding to the pressure of the used stylus. Should you use a separate pick-up system, please follow the manufacturer's instruments. Set the anti-skating control knob to the same value as the stylus pressure. Placement · · · Do not place the unit in a location where it will be exposed to direct sunlight or near a heating appliance. Do not place the unit in a location where there is high humidity or a lot of dust. Cartridge may pick up slight sound pressure or vibrations of the speakers coming along the floor or though the air resulting in howling. · The legs have functions for adjusting the height of the unit itself. Connect the power cord to the auxiliary power outlet on the rear panel of your amplifier or receiver or to a household AC outlet. Connect the unit output terminals to the the PHONO jack of your American DJ Mixer or receiver. Output terminals Mixer (Receiver) L (White) (18) ----------------------------> L Channel R (Red) (19) -----------------------------> R Channel GND (Spade) (21) ---------------------> Ground NOTE: Be sure to connect the ground terminals firmly to the Mixer or receiver. If this connection is not made or is loose, a power source "HUM" will result. TTB-2500 User Instructions page 3 User Instructions Operation 1. Push the power button (4) to turn on the power, the speed indicator (8) and the strobe-illuminator will light up. When playing a 45-rpm record with a large center hole, place the 45-rpm adapter (1) on the center spindle. Press the Start/Stop button (5), the turntable platter will start to rotate. Set the cueing lever to the down position, the tonearm will descend slowly onto the record and begin playing. When play is finished, raise the cueing lever, move the tonearm with arm clasp. · SUSPEND PLAY - Set the cueing lever to "UP" position during play, the stylus tip of the cartridge will be lifted from the record. [. . . ] Future American DJ mixers will be equipped with the "Fader Start" function. (1/4" connection) Beat Indicator (22) · The Beat output sends a mono pulse signal and may be used with a separate beat analyzer. (RCA connection) Maintenance · · · · Clean the stylus periodically with a soft brush to prevent the accumulation of dust. From time to time, the dust cover and turntable cabinet should be wiped down with a soft, dry cloth. [. . . ]