User manual AMX AXB-TCTCR TELEVISION CONTROLLERRECEIVER

[. . . ] instruction manual AXB-TC and AXB-TCR Television Controllers AXlink Bus Controllers AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: · · · Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, and MX Series products are warranted for a period of one (1) year. AMX Lighting products are guaranteed to switch on and off any load that is properly connected to our lighting products, as long as the AMX Lighting products are under warranty. AMX Corporation does guarantee the control of dimmable loads that are properly connected to our lighting products. [. . . ] Drill four #6-32 holes into the SE-TC mounting surface in the locations shown in FIG. Mount the SE-TC. 10 AXB-TC and AXB-TCR Television Controllers Installation and Wiring Television Power Sensor Adjustment After connecting the CC-IR to the television, the power sensing POT, on the rear of the television controller (see FIG. 1 on page 1), may require adjustment to detect the television's power status: Use a Phillips-head screwdriver and flat-blade tool (non-conducting) to adjust the POT screw. Locate the POT screw on the circuit card and turn it clockwise 20 full turns or until it clicks. The red TV Sensor indicator, located on the front panel, should be dark. Turn the POT screw counterclockwise until the TV Sensor indicator lights. If the TV Sensor indicator is lit, turn the POT screw clockwise until the indicator goes dark. Reattach the enclosure and refasten the two screws. IR Signal Attenuation Adjustment If you experience television control problems after connecting a CC-IRC IR Emitter to the television, the television may be too sensitive to interpret the IR signals generated by the television controller. You can use the IR signal attenuation POT, located inside the television controller (FIG. Refer to Internal Jumper Settings section on page 5 to put the AXB-TC or AXB-TCR in IR attenuation mode. IR signal attenuation POT front FIG. 11 IR signal attenuation POT location Use a Phillips-head screwdriver and flat-blade tool (non-conducting) to adjust the POT screw. Static electricity can damage electronic circuitry. Discharge any static electricity from your body by touching a grounded metal object before adjusting the POT. AXB-TC and AXB-TCR Television Controllers 11 Installation and Wiring 1. Remove the two Phillips-head screws on the bottom of the television controller enclosure. Pull the two enclosure halves apart and set the bottom portion of the enclosure on a flat surface. Locate the POT screw on the circuit card and turn it counterclockwise with a flat-blade tool until it stops. Turn the POT screw clockwise one-eighth turn to increase signal saturation. If not, repeat this step until the television performs the correct operation. Send an IR control signal to the television for all programmed operations. Reattach the enclosure and refasten the two screws. Replacing the Lithium Battery There is a lithium battery (FIG. 12), with a life of approximately five years, in the television controller that protects stored presets if there is a power loss. The battery is not used when DC power is supplied to the television controller. You should write down the replacement date on a sticker or label by adding 5 years to the date of installation, and attach it to the bottom of the television controller. Battery (CR2025 type) socket FIG. [. . . ] Then use the up/down arrow keys to select the interface communications speed. Make sure that the BAUD RATE selections match the settings on the Axcess System Master Controller. Press F10 to save the selected setting and to exit the CONFIGURE screen. After establishing the communications configuration, upgrade firmware as follows: 1. [. . . ]