User manual AMX RDM-3FDB TRIPLE FDB MODULE, 1,920 W (X3)
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AMX RDM-3FDB TRIPLE FDB MODULE, 1,920 W (X3). We hope that this AMX RDM-3FDB TRIPLE FDB MODULE, 1,920 W (X3) user guide will be useful to you.
 |
AMX RDM-3FDB TRIPLE FDB MODULE, 1,920 W (X3) : Download the complete user guide (436 Ko) |
Manual abstract: user guide AMX RDM-3FDB TRIPLE FDB MODULE, 1,920 W (X3)
Detailed instructions for use are in the User's Guide.
[. . . ] Installation Sheet
RDM-3FDB Triple Channel Lutron FDB Ballast Dimmer 1900 W
The RDM-3FDB Triple Channel Ballast Dimmer is a 1920 W positive air gap relay and dimmer, built for strength and for reliable switching/dimming of Lutron FDB ballasts. [. . . ] 2 RDM-3FDB connections
Lighting Application Drawing
Ballast C All neutrals are common to the Neutral block in the enclosure. Provide a Neutral separate neutral for each load.
Neutral Positive air gap relay Fuse Line in (HOT) Switched
Dimmed
Ballast
BALLAST
Florescent Ballast Low-voltage control wiring: 4-pin connector to AMX Lighting master controller Circuit breaker panel The fuses protect the dimming circuit from a low impedance load. · The fuse would blow if it were incorrectly wired · Catastrophic ballast failure · Reversing switched and dimmed circuits · Reversing dimmed and line circuits. 1 RDM-3FDB
RDM-3FDB UL and C-UL Ratings
· · · · · · · · · · · · · · · · · · · · · · 120 VAC, 1920 W 240/277 VAC, 1920 W Most 3-wire dimmable fluorescent ballasts Lutron© Hi-Lume® FDB Ballasts Lutron Eco-10 Dimmable Ballasts Dimensions (HW): 10. 0" x 2. 75" (25. 4 cm x 6. 99 cm) Dimmed output protected by a 250 mA GMA 5 x 20 mm fuse Phase dependant Use wires rated at 75°C (167°F) Torque terminals to 20 in-lbs. (0. 712 kg) BTU/hr: 5 Control current: 85 mA @ 12 VDC For use with FDB ballasts All Class 1 wiring must be connected to proper terminals. 3 RDM-3FDB wiring configuration
Specifications
Caution: Pre-Installation Notes
AMX Corporation reserves the right to alter specifications without notice at any time.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). [. . . ] 3000 research drive, richardson, TX 75082 USA · 469. 624. 8000 · 800. 222. 0193 · fax 469. 624. 7153 · technical support 800. 932. 6993 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE AMX RDM-3FDB TRIPLE FDB MODULE, 1,920 W (X3)
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AMX RDM-3FDB TRIPLE FDB MODULE, 1,920 W (X3) will begin.