User manual AMX RDM-HDC HEAVY-DUTY DC MODULE, 2,400 W, 0-12 VDC

[. . . ] Installation Sheet RDM-HDC Heavy Duty DC Module 2400 W, 0-12 VDC The RDM-HDC Heavy Duty DC Module is a heavy-duty 2400 W module for dimming of fluorescent ballast loads. [. . . ] This module may require extra power from the AXlink connection or an external power supply connected to the control card. Connecting the RDM-HDC to the AMX Lighting Master Neutral High voltage Line in Load - out (LV) + out (LV) Low-voltage Pin 4 (GND) Pin 3 (RLY) Pin 2 (DIM) Pin 1 (+12 V) RDM-HDC 4-pin module connector GND 3 (-) 2 (DIM) 1 (+) 4-pin plug from RDM series module Note: The 4-pin plugs from the module connector to the 4-pin connector on the master (black plug cover facing up). 2 Connecting the RDM-HDC and AMX Lighting Master Lighting Application Drawings Neutral Line in (HOT) Low-voltage control wiring: 4-pin connector to AMX Lighting master controller + Florescent Ballast Ballast RDM-HDC Load Neutral CON LOAD LINE NEUT FIG. 1 RDM-HDC Low-voltage wire rated to 300 V RDM-HDC UL and C-UL Ratings · · · 120 VAC, 50/60 Hz, 2400 W 240/277 VAC, 50/60 Hz, 2400 W Control Out: 50 mA, 12 VDC sourcing/sinking Four-wire dimmable ballasts All low-voltage DC controlled ballasts Dimensions (HW): 10" x 2. 75" (25. 4 cm x 6. 99 cm) Non-phase dependant Use wires rated at 75°C (167°F) Torque terminals to 20 in-lbs. wire size: 10 AWG (4 mm²) Wire stripping length: 0. 28" (7 mm) Weight: 1. 3 lbs. (0. 590 kg) BTU/hr: 150 Control current: 150 mA @ 12 VDC Circuit breaker panel FIG. 3 RDM-HDC application wiring Suggested Dimmed Loads · · · · · · · · · · · Warning: Failure to ground the ballast may cause ballast failure Specifications AMX Corporation reserves the right to alter specifications without notice at any time. For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). [. . . ] 3000 research drive, richardson, TX 75082 USA · 469. 624. 8000 · 800. 222. 0193 · fax 469. 624. 7153 · technical support 800. 932. 6993 [. . . ]