User manual BELSON C21-1-4

[. . . ] 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. 14) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 15) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. [. . . ] The rinse aid container is situated on the inside of the door: It should be filled up when the low rinse aid indicator light "T" flashes. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. If, on the other hand, the dishes have white streaks, then turn the dosage adjuster down to a lower setting. Warning Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one. If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the formation of white streaks on your dishes or on the interior of the appliance. Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container. If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no. In any case, please read the manufacturer's instructions on the packet. If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number of cycles. 16 ARISTON DISHWASHER - Instructions for installation and use A wash cycle for every degree of soil Select the right wash cycle D ISHWASHER "AUTO" wash cycles This means that your dishwasher is equipped with a sensor which evaluate how dirty your dishes are and allows these wash cycles to adjust automatically, to provide you with a more efficient and economic wash cycle. The inlet could get blocked, causing dishwasher is provided with water damage to your dishwasher. Supply and drain hoses, which can be directed towards the left or right Hot water connection. Your dishwasher can be supplied with hot water from the mains Levelling. Supply (if you have a central heating Once the appliance is positioned, system with radiators) at a tempeadjust the feet by screwing them rature of no more than 60°C. In or out depending on how high In this case, the wash cycle time you want it and to level it so that it will be about 15 minutes shorter is horizontal. Make sure that it is and the wash will be slightly less not inclined more than 2 degrees. If the appliance is level, it will help The connection must be made to ensure its correct operation. Hot water supply following the same procedures as those indicated Adjusting the back Feet for the cold water connection. Insert the appliance into the cutout and then adjust the height using the Anti-flooding protection screws located on the front bottom Your dishwasher is provided with a part of the machine. Screwdriver to turn the screws in water supply in the event of leaks The pipe should not be immersed the clockwise or anti-clockwise inside the appliance. Direction to increase or decrease equipped with a water inlet hose the height respectively. [. . . ] The food particles are removed from the wash water, allowing it to be recirculated during the cycle, filtered perfectly. For this reason, it is a good idea to remove the larger food particles trapped inside the cup “C” and the semi-circular filter A after each wash; pull the cup handle upwards to remove them. The entire filter assembly should be cleaned thoroughly once a month: cup C + semi-circular filter A + cylindrical filter B. Reassemble the filter parts (as shown in the figure) and reinsert the whole assembly into the dishwasher. [. . . ]