User manual CARVIN AC120

[. . . ] You'll find the AC120 Power Conditioner an invaluable addition to your rack. 8 9 10 NOTE: The AC120 is fitted with a 15AMP circuit breaker so the maximum total current available to the all eight outlets is 15AMPS. A maximum of one high powered amplifier can be plugged into the AC120 (such as DCM1000's and larger). 2. Press the lamp switch up for HIGH illumination and push down for LOW illumination. 3. [. . . ] In the event you have to reship your unit, always use the original carton and packing material. CARVIN and the shipping company are not liable for any damage caused by improper packing. Please allow several days for the rest of your order to arrive before inquiring. RECORD THE SERIAL NUMBER on the enclosed warranty card or below on this manual for your records. Keep your portion of the card and return the portion with your name and comments to us. Serial No. _____________________ Invoice Date_______________ 76-00120 1099 9. CIRCUIT BREAKER A 15A circuit breaker is provided for over current protection. 10. AC OUTLETS The rear AC outlets have been positioned to allow for up to four "wall-warts" and four standard spaced plugs to be used simultaneously. Before plugging gear into the AC120, check voltage level on the LINE VOLTAGE meter and verify that it is in the safe range specified by the gear manufacture. Also be sure to verify that the green SAFETY GROUND indicator is illuminated. AC120 SPECIFICATIONS: PROTECTION One EMI Filter & Three Transient/Surge Absorbers Circuit Breaker 15A Power Rating 120V - 15A - 1800VA Dimensions 1 3/4" H x 19" W x 6 1/2" D Weight 7 lbs 12340 World Trade Drive, San Diego, CA 92128 (800) 854-2235 www. carvin. com LAMP replacement For Lamp replacement do, the following: 1. With the other hand, hold tube cap, turn cap clockwise one click and pull cap off. With finger, nudge lamp out while pushing the tube back into AC120 chassis. Be sure to line up the lower flat sides of lamp socket with the double guides inside of lamp tubes. Lamp should seat all the way inside of tube inorder for light to shine through tube light hole. Hold tube with one hand place tube cap on tube with the other hand and turn one click counter clockwise. Cap should not come off when pulling tube out. CAUTION Light tubes may be hot REPLACEMENT LAMP 6 watt 120V candelabra Carvin part # 70-96120 This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. LIMITED WARRANTY Your Carvin product is guaranteed against failure for 1 YEAR unless otherwise stated. Carvin will service and supply all parts at no charge to the customer providing the unit is under warranty. Carvin assumes no responsibility for horn drivers or speakers damaged by this unit. [. . . ] All other servicing should be referred to qualified service personnel. FUSING: If your unit is equipped with a fuse receptacle, replace only with the same type fuse. Refer to replacement text on the unit for correct fuse type. SAFETY INSTRUCTIONS (EUROPEAN) The conductors in the AC power cord are colored in accordance with the following code. GREEN & YELLOW--Earth BLUE--Neutral BROWN--Live U. K. [. . . ]