User manual CARVIN TR1522

[. . . ] CARVIN ENGINEER DATA TR1522 HIGH POWERED TRAPEZOID SUBWOOFER SPEAKER ENCLOSURE BUILT-IN CROSSOVER INSTRUCTIONS Your subwoofer system comes with an 250Hz 12dB/octave built-in crossover, which is switched IN when you receive your system. By removing the dust cap below the words CROSSOVER on the rear connect plate, you can switch the crossover OUT. [. . . ] When returning defective driver(s), remove them from the enclosure to reduce shipping costs . Your driver(s) will be returned COD for the cost of shipping and reconditioning if not covered under warranty. Congratulations on your selection of the 1522 subwoofer. As one of the finest subwoofer systems made, the TR1522 will reproduce your low frequencies with plenty of power and punch. The two high powered heavy-duty cast frame 15" woofers are efficient even under the most stressful and intense power levels. The computer-aided tuned-ported enclosure offers the best frequency response. The featured Trapezoid enclosure offers a 15° angle off-set on each side for you to stack or hang the enclosures together creating full, gapless coverage. Hookups are easy too, with either 1/4" jacks or professional Twist-Lok connectors. RECEIVING INSPECTION INSPECT YOUR SPEAKER FOR ANY DAMAGE which may have occurred during shipping. If any damage is found, please notify the shipping company & CARVIN. In the event you have to re-ship your unit, always use the original carton and packing material. CARVIN and the shipping company are not liable for any damage caused by improper packing. [. . . ] Serial No. _____________________ Invoice Date________________ SPEAKER CABLES The TR1522 can accept both the SP 12 gauge or the PH 16 gauge 1/4" speaker cables. Due to the high power capacity of the TR1522, it is recommended to use the high current SP Twist-Lok cables (Carvin part numbers SP25 or SP50). 76-01522A 0101 12340 World Trade Drive, San Diego, CA 92128 800. 854. 2235 www. carvin. com [. . . ]