User manual COBY MP-CD455 Instruction Manual

[. . . ] (A polarized plug has two blades where one is wider than the other; the wide blade is provided for your safety. ) Do not place heavy objects on the power cord. Protect the cord from being walked on, pinched by objects, or torn and exposed to liquids (especially at plugs, convenience receptacles, and the point at which they exit from the device). Use of attachments/accessories not recommended by the product manufacturer may be hazardous. [. . . ] Unplug the power supply, open the CD door, and clean the lens as follows: · · For Dust or Dry Particles - use a camera lens brush/blower to blow on the lens a few times. Then, wipe the lens gently with the brush, and blow on the lens once more. For Fingerprints - use a dry cotton swab to wipe the lens in a straight line radially from the center to the outside edge. -6- GENERAL OPERATION Power Sources AC Power Before connecting the unit to an AC outlet, make sure that the operating voltage of the unit has been properly set to match the voltage of your local power supply (110V or 220V). When you have confirmed that the proper voltage has been set, use the supplied AC power cord to connect the unit to an AC outlet. DC Power (Battery Operation) Remove the battery compartment cover on the rear of the unit and insert 8 "C" batteries. Make sure that the polarity of the batteries (+/-) match the markings on the inside of the battery compartment. Replace the battery compartment cover. Stereo Headphone Jack Make sure to lower the volume on the unit prior to use with headphones to avoid damage to your hearing or the headphones. For private listening, connect a pair of headphones to the headphone jack on the unit. The speakers on the unit will be disconnected during headphone use. Power On / Function Modes Use the Function switch to change the operation mode of the unit. Set the switch to "MP3/CD" to play CDs and MP3-CDs (MP3/CD mode), set the switch to "Radio" to listen to the radio (Radio mode), and set the switch to "Off" to turn off the unit. RADIO OPERATION Set the Function switch to the RADIO position to listen to AM/FM radio broadcasts. · To listen to FM broadcasts, set the Band switch to the FM or FM ST position (FM ST = FM Stereo). The FM Stereo indicator will light up when the tuner is receiving an FM Stereo broadcast. Extend the telescopic rod antenna fully and adjust its position to obtain the best FM broadcast reception. The AM antenna is built into the unit; turn or move the entire unit to obtain the best AM reception. Turn the tuning dial to change the radio station. · · -- MP3/CD OPERATION Set the Function switch to the MP3/CD position to listen to MP3-CDs or regular audio CDs. What is an MP3-CD? MP3-CDs are CDs that contain MP3 music files. Approximately 200 files can fit on one 700MB CD -- in comparison, a regular audio CD can fit approximately 20 tracks. [. . . ] If the unit is in Program mode, the unit will play the entire Program list repeatedly (see the Program Mode section for more information). Notes · The program list can store a maximum of 20 tracks. · The program list will be lost if STOP is pressed twice, the CD door is opened, or the unit is turned off. · If is pressed before PROG during track selection, the track will not be added to the program list. [. . . ]