User manual DOMETIC PP604

[. . . ] If the device is resold, this instruction manual must be handed over to the purchaser along with the device. Caution Safety instruction: Failure to observe this instruction can cause material damage and impair the function of the device. caution Safety instruction relating to a danger from an electrical current or voltage. [. . . ] Operate the device only if you are certain that the housing and the cables are undamaged. PerfectPower PP152: inverter with cable for a 12 V or socket PP152 and four holders PerfectPower PP154: inverter with cable for a 24 V socket and four holders PerfectPower PP402: inverter with terminals for a 12 V battery and four holders PerfectPower PP404: inverter with terminals for a 24 V battery and four holders PerfectPower PP602: inverter with terminals for a 12 V battery and four holders PerfectPower PP604: inverter with terminals for a 24 V battery and four holders PP154 PP402 PP404 PP602 PP604 The inverters are used to convert a direct current of 12 V or 24 V into a 230 V AC supply of 50 Hz. The PerfectPower inverters can be operated wherever there is a 12 V DC supply (for PP152, PP402, PP602) or a 24 V DC supply (for PP154, PP404, PP604). The devices are additionally cooled with a load and temperature-dependent fan. The inverter is equipped with protection against thermal and electrical overloading, as well as excess and insufficient voltage. The inverter switches off: If its internal temperature is too high If the load exceed the values stated above If the input voltage is too high or too low The inverter can be switched on and off using the switch directly on the device or using an external switch. Note Note when connecting devices with an electrical drive (such as power drills and refrigerators), that they often need more power than is stated on the type plate. When selecting the installation location, observe the following instructions: The inverter can be mounted horizontally or vertically. The inverter must be installed in a place that is protected from moisture. A ventilation system must be present for installations in small, enclosed spaces. The air intake on the underside or the air outlet on the back of the inverter must remain clear. For ambient temperatures higher than 40 °C (such as in engine or heating compartments, or direct sunlight), the heat from the inverter under load can lead to the automatic shut-off of the inverter. Before drilling any holes, ensure that no electrical cables or other parts of the vehicle can be damaged by drilling, sawing and filing. 1 4, page 3) must be connected to the positive wire and the two side brackets of the plug (fig. Caution The rating of the socket, the supply cable and the fuse must be at least 15 amps. Caution Only extend the connection line with cables with an equal or greater cross section. [. . . ] For repair and guarantee processing, please include the following documents when you send in the device: A copy of the receipt with purchasing date Reason for the claim or a description of the fault If you wish to finally dispose of the device, ask your local recycling centre or specialist dealer for details about how to do this in accordance with the applicable disposal regulations. Technical data Technical data for specific devices: PP152 Item number Constant output power Peak output power Dimensions Weight PP152 150 W 350 W PP402 Item number Constant output power Peak output power Dimensions Weight PP402 350 W 700 W PP602 Item number Constant output power Peak output power Dimensions Weight PP602 550 W 1100 W Kontaktens mellersta stift (bild 1 4, sida 3) är kopplad till plusledningen och de två byglarna på sidorna (bild 1 5, sida 3) är kopplade till minusledningen. Se till att kontakten är god när stickkontakten ansluts till uttaget. [. . . ]