User manual DOMETIC RC1200 EGP
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DOMETIC RC1200 EGP. We hope that this DOMETIC RC1200 EGP user guide will be useful to you.
Manual abstract: user guide DOMETIC RC1200 EGP
Detailed instructions for use are in the User's Guide.
[. . . ] Manufacturers' food storage recommendations should be strictly adhered to. Refer to relevant instructions for food and drink storage under point 13. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. [. . . ] Other versions Your refrigerator has a 3-wire mains lead which is intended for connection to a 3-pin plug and a properly earthed socket outlet. IMPORTANT: The wires in the mains lead of this appliance are coloured in accordance with the following code: GREEN-AND-YELLOW: EARTH BLUE: NEUTRAL BROWN: LIVE As the colours of the wires in the mains lead may not correspond with the coloured markings identifiying the terminals in your plug, proceed as follows: the wire which is coloured GREENAND-YELLOW must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green-and-yellow. The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red. In other cases, the circuit to which the refrigerator is connected should be fitted with a 5 amp fuse.
4
To turn on (Fig. Only after approximately 1 hour will the unit become noticably cool (frost on evaporator). The temperature can be regulated using the thermostat knob: '0'=off, 17 increasing degrees of coolness. After sufficient cooling (approximately 5 hours), the thermostat position can be set to a lower temperature, between 2-5. 1) Turn thermostat knob (A) anticlockwise to position '0' (a slight resistance will be felt just before this position). A safety fuse must be installed in the electricity supply between battery and refrigerator in a duct. cable lengths Cable cross section 12 V until 2. 5 m 2. 5 mm2 until 4. 0 m 4. 0 mm2 until 6. 0 m 6. 0 mm2 It is not necessary to consider the polarity when connecting the unit. Check that the battery voltage corresponds with the line-voltage data on the cooling unit type-plate. If no battery is used independently of the vehicle, the cooling unit is only to be used when the vehicle is in motion, since, when the engine is not running, the battery can discharge to such an extent that the engine will not restart. Recommendation: Before a journey, pre-cool the unit using the supply voltage. To turn on The car plug fitted to the connecting cable is to be plugged into the socket/cigar lighter (car plugs are not supplied with every model). When using battery operation, the cooling performance is not thermostatically regulated, i. e. knob (A) is ineffective.
5
When knob (A) is ineffective or if the temperature is unnecessarily too low: Turn off unit Pull out plug from socket.
8. Liquid gas operation
Do not use any additional form of energy (mains/battery). The specified gas-connection pressure is given in mbar on the type plate (see back of appliance). It is important that a non adjustable pressureregulator is used to reduce the pressure in the gas cylinder to the operating pressure specified on the rating-plate, no other pressure may be used. Needle valve operated gas control taps are NOT suitable for use with this appliance and must not be used as a substitute for a pressure regulator.
9. Connecting the cooling unit to the gas cylinder
(The following instructions refer in the main to coolers manufactured for the United Kingdom. [. . . ] 159g H2O + 86g NH3
The refrigeration cycle has been checked for leaks. Sodium chromate is used for corrosion protection (less than 2 weight % of the coolant).
19. Recycling
After unpacking the appliance, the packing materials should be delivered to a local collection site. At the end of its useful lifetime, the appliance should be delivered to a specialized collection and reprocessing firm, which reclaims the usable materials. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DOMETIC RC1200 EGP
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DOMETIC RC1200 EGP will begin.