User manual FISHMAN MATRIX INTY PREAMP INSTALLATION GUIDE

[. . . ] MATRIX INFINITY PREAMP INSTALLATION GUIDE www. fishman. com Read Me First! Installation of this product is a straightforward procedure, but we recommend this job only if you are an experienced repair technician. 5. Open the preamp body by unscrewing the single screw on the side opposite the Matrix Infinty logo. Flip the preamp over so the circuit board remains in the plastic housing (figure 2). [. . . ] Remove any lacquer and/or buffing compound from this area using fine grit sandpaper. Clean this surface with an alcohol wipe or a cotton swab moistened with rubbing alcohol. Note: For the strongest bond we recommend that you now apply a water-based primer/sealer to the bare wood inside the soundhole. Peel back the release film on the bottom of the preamp module and fasten the preamp to the underside of the soundhole. Install the pickup per Acoustic Matrix Installation Instructions. Figure 1. Figure 2. 1 Battery Bag Install the battery bag on or near the neck block as shown in figure 1. Clean the area where you will mount the bag with an alcohol wipe or cotton swab moistened with rubbing alcohol. Peel off the plastic film from the Velcro patch and attach the bag at the chosen location. To set the adhesive, burnish the entire area of the patch, especially the edges. The adhesive under the Velcro patch requires 24 hours to achieve a full bond, so take care to not stress the adhesive if you remove the battery bag after the initial installation. Figure 3. Installation Options Nylon String Guitar Mount An optional control module mount is provided in the package for use with nylon string guitars whose bracing patterns may interfere with the standard mount. Carefully push back the retaining latch and rock the control module circuit board away from the plastic mount as shown in figure 3. Locate the included nylon string guitar mount and snap it into place as shown in figure 4. Installation Without Controls Under normal installations, the Volume and Tone control module is installed in the soundhole. [. . . ] The output will appear on the ring connection when a tip-ring-sleeve 1/4" jack is inserted. 2 514-300-003 Rev B 5-08 Bass Flat Figure 4. With Volume & Tone controls installed If controls are removed: 1. Choose Flat voicing or Figure 5. Bass Boost with switch 1. Figure 6. [. . . ]