Detailed instructions for use are in the User's Guide.
[. . . ] 988-0148-831 www. lowrance. com
iFINDER Explorer
Handheld Mapping GPS Receiver
Operation Instructions
Copyright © 2006 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance. Any unauthorized commercial distribution of this manual is strictly prohibited. Energizer and e2 are registered trademarks of Energizer Holdings, Inc.
Points of Interest Data in this unit are by infoUSA, copyright 2001-2005, All Rights Reserved. [. . . ] To clear the cursor, press EXIT and the map will be switched back to the current or last known position.
Find Distance to Another Location
1. A rubber band line appears, connecting your current position to the cursor's location. The distance along that line will appear in the lower right-hand corner of the screen. Press EXIT|EXIT to return to regular operation.
49
The distance to Dallas from the starting point is 211. 1 miles.
Find Distance from Point to Point
You can also measure distance between two other points on the map. A rubber band line appears, connecting your current position to the cursor's location. The rubber band line reappears, connecting the first point you set to the cursor. The distance along that line will appear in the lower right-hand corner of the screen. Press EXIT|EXIT to return to the main page display.
Find Your Current Position
When you turn on the iFINDER, it automatically searches for satellites and under clear sky conditions, calculates its position in approximately one minute or less. NOTE: Clear sky means open sky, unobstructed by terrain, dense foliage or structures. If for some reason satellite acquisition takes longer, you may be inside a structure or vehicle or in terrain that is blocking signal reception. To correct this, be sure you are positioned so the unit has as clear a view of the sky as possible, then turn the unit off and back on again. If the cursor is activated, any information the unit gives you will be based on the cursor position, not your own. If you want to find where you are, just press EXIT until the cursor goes away and the map snaps back to your position.
50
Icons
Icons are graphic symbols used to mark some location, personal point of interest or event. They can be placed on the map screen, saved and recalled later for navigation purposes. The iFINDER has 42 different symbols to choose from when creating an icon. Icons are similar to waypoints, but they do not store as much information and you can't use a menu to navigate to icons as with waypoints. You can create an icon at the cursor position on the map or at your current position, while you are navigating.
Create Icon on Map
1. Press and hold ENT until the screen displays Save Icon, then release the ENT key. The icon appears on the map.
Save icon menu (left) with Select symbol menu (right). While you are traveling, press and hold ENT until the screen shows the Save Icon menu, then release the ENT key. You can delete all the icons at one time, delete all icons represented by a particular symbol or use the cursor to delete an icon selected from the map. Press to DELETE ALL ICONS, DELETE BY SYMBOL or DELETE FROM MAP and press ENT. [. . . ] If you're in the United States and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number:
800-324-1356
8 a. m. [. . . ]