User manual MIELE DA 446-4

[. . . ] Operating and installation instructions Cooker hood DA 446-4, DA 447-4, DA 447-4 EXT, DA 449-4, DA 449-4 EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M. -Nr. 36 2 Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. cling film, polystyrene and plastic wrappings must be kept out of the reach of babies and young children. Dispose of or recycle all packaging materials safely as soon as possible. Disposal of your old appliance Electrical and electronic appliances often contain materials which, if handled or disposed of incorrectly, could be potentially hazardous to human health and to the environment. [. . . ] The number of flashing lamps shows the percentage of the operating time which has already been used up. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % ^ Press the On/Off control to switch the fan off. The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. ^ Press the run-on option control and the grease filter control at the same time. The indicator lamp for the grease filter control and one of the ­ / + indicator lamps will flash. 15 Operation Activating and altering the operating hours counter for the charcoal filter (in recirculation mode) The ­ / + indicator lamps show the time which has been set: 1st lamp from the left = 20 hours 2nd lamp from the left = 30 hours 3rd lamp from the left = 40 hours 4th lamp from the left = 50 hours ^ Use the ­ / + controls to select the desired time. On delivery, the operating hours counter for the charcoal filter is switched off, For recirculation mode, the operating hours counter needs to be set to suit the type of cooking you do: ^ Confirm the selection by pressing the grease filter control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Press the On/Off control to switch the fan off. ^ Press the run-on option and the charcoal filter controls at the same time. The indicator lamp for the charcoal filter control and one of the lamps above the ­ / + controls will flash. The ­ / + control lamps show the time which has been set: 1st lamp from the left = 120 hours 2nd lamp from the left = 180 hours 3rd lamp from the left = 240 hours 4th lamp from the left = deactivated 16 Operation ^ Use the ­ / + controls to select the desired time. Reading the operating hours counter for the charcoal filter To check the percentage of time set already used: ^ Confirm the selection by pressing the charcoal filter control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. Resetting the operating hours counter for the charcoal filter ^ Press the On/Off control to switch the fan on. One or more of the indicator lamps for the ­ / + controls will flash. The indicator lamp for the charcoal filter control will light up after the cooker hood has operated for the number of hours set. ^ Press and hold the charcoal filter control for about 3 seconds while the fan is switched on. The number of flashing lamps shows the percentage of the operating time which has already been used up. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. 17 Cleaning and care Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: ­ it is switched off at the wall socket and the plug removed, or ­ the fuse is withdrawn from the fused spur connection unit, or ­ the mains fuse is withdrawn, or ­ the screw-out fuse is removed (in countries where this is applicable). E-Cloth ^ A microfibre E-Cloth is available from the Miele UK Spare Parts Department, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. Do not use any of the following to clean any surfaces: ­ cleaning agents containing soda, acids, chlorides or solvents, ­ abrasive cleaning agents, e. g. pot scourers, or sponges which have been previously used with abrasive cleaning agents. Important for appliances with stainless steel housing (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-Cloth, or with a proprietary non-abrasive cleaning agent designed specifically for use on stainless steel. To help prevent re-soiling, a conditioning agent for stainless steel such as Neoblank (available from the Miele UK Spare Parts Department) can also be used. Follow the manufacturer's instructions and apply sparingly with an even pressure following the direction of the grain. Housing General notes The surfaces and controls are susceptible to scratches and abrasions. ^ All external surfaces and controls can be cleaned using a Miele E-Cloth, or with warm water and a little washing-up liquid applied with a well wrung-out soft sponge or cloth. [. . . ] Do not connect the appliance to the mains electricity supply by an extension lead. Connection of this appliance should be made via a suitable isolator or a double pole fused spur connection unit which complies with national and local safety regulations and the On-Off switch should be easily accessible after the appliance has been built in. When switched off there must be an all-pole contact gap of 3 mm in the switch (including switch, fuses and relays according to EN 60335). If the switch is not accessible after installation (depending on country), an additional means of disconnection must 33 For extra safety it is advisable to install a residual current device (RCD) with a trip current of 30 mA. [. . . ]