User manual MIELE G 2220

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MIELE G 2220. We hope that this MIELE G 2220 user guide will be useful to you.


MIELE G 2220 : Download the complete user guide (2568 Ko)

Manual abstract: user guide MIELE G 2220

Detailed instructions for use are in the User's Guide.

[. . . ] Operating instructions for dishwashers To avoid the risk of accidents or damage to the appliance it is essential to read these instructions as well as the installation plan before it is installed and used for the first time. G M. -Nr. 61 4 Description of the appliance Appliance overview a Upper spray arm (not visible) b Cutlery tray (depending on model) c Upper basket d Middle spray arm e Air inlet for drying (depending on model) f Lower spray arm g Filter combination h Data plate i Child safety lock in door grip (not visible) j Rinse aid reservoir k Dual compartment detergent dispenser l Salt reservoir 5 Description of the appliance Control panel a Programmes b Display c Tab indicator d Programme sequence indicators e On/Off button s f Check/Refill indicators g Start/Stop button with indicator light h Delay start button with indicator light i Tab button j Programme selector button This instruction book applies to several different dishwasher models. The specific dishwasher models below are referred to as follows: G 1220 etc. = G 2XXX The model numbers G 1XXX and G 2XXX used in this book refer to the model designation specified on the data plate of the appliance (and not the description on the control panel). [. . . ] ^ Make sure that the detergent packaging is properly closed after use to avoid it getting damp and becoming lumpy. 30 Operation Switching on ^ Make sure the spray arms are not obstructed. The Start/Stop indicator light flashes and the indicator light comes on next to the last programme selected. Starting a programme ^ Select the programme required using the programme selector button. The programme duration will appear in the hours and minutes in the display. You can now select an additional function (see "Additional functions"). The Start/Stop and Wash/Rinse indicators and the indicator for the programme selected will light up. If the "2 in 1-Tab" or "3 in 1-Tab" function has been selected, the corresponding indicator will light up as well. Otherwise the programme must continue to the end so that important programme stages (e. g. reactivating the water softener) are not omitted. Selecting a programme Choose your programme according to the type of load and how dirty it is. The different programmes and their uses are described in the programme chart later on in this booklet. 31 Operation Display The duration of the programme selected appears in hours and minutes in the display before the programme begins. During the programme, the time left until the end of the programme is displayed. This is partly because of the water inlet temperature at each intake, and partly because of the amount and soiling level of the crockery. When a programme is selected for the first time, the display shows an average time for a cold water intake. The times shown in the programme chart refer to standard test loads and temperatures. Each time a programme is run, the electronic unit takes the new conditions into account, and calculates the time required. At the end of a programme A programme has finished when a "0" appears in the display and the "End" programme sequence indicator lights up. The dishwasher can now be opened and unloaded (see "Unloading the dishwasher"). , To prevent the risk of steam damage to the worktop edging above the dishwasher, it is advisable to leave the door closed until you are ready to unload the crockery. Alternatively you can open the door fully until the crockery is cool enough to unload. Do not leave the door only partially open. Switching off At the end of a programme: ^ Switch the dishwasher off with the On/Off button s. The dishwasher will continue to use electricity until the On/Off button s is switched off. whilst on holiday, the stopcock should be turned off. Programme sequence indicators After a programme has been started, the current stage of the programme is indicated by the programme sequence indicator lights. 32 Operation Unloading the dishwasher Dishes tend to break and chip more easily when they are hot. Allow the dishes to cool until they are comfortable enough to handle before unloading them. If you open the door fully after switching off, the dishes will cool much faster. ^ First unload the lower basket, then the upper basket and cutlery tray (depending on model). [. . . ] Extension leads do not guarantee the required safety of the appliance (e. g. danger of overheating). WARNING: THIS APPLIANCE MUST BE EARTHED 58 Plumbing Connection to the water supply , Water in the dishwasher must not be used as drinking water. ­ The dishwasher may be connected to a cold or hot water supply, max. We would only recommend connection to a hot water supply if it is economical, e. g. When connected to a hot water supply all programme stages which would otherwise be carried out with cold water will be carried out with hot water. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE MIELE G 2220




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MIELE G 2220 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.