User manual MIELE KM 5775

[. . . ] Operating and Installation instructions Ceramic hobs with induction KM 5731 / KM 5732 / KM 5733 KM 5736 / KM 5737 / KM 5752 KM 5753 / KM 5755 / KM 5757 KM 5775 To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time. Gir M. -Nr. 70 3 Guide to the appliance KM 5731 abcd Cooking zones e Cooking zone controls and displays (see "Cooking zone controls and displays") f Timer control and display (see "Timer control and display") g Safety lock indicator lamp h Safety lock sensor switch i Hob ON/OFF sensor switch 4 Guide to the appliance KM 5732 / KM 5736 / KM 5737 abcd Cooking zones e Cooking zone controls and displays (see "Cooking zone controls and displays") f Timer control and display (see "Timer control and display") g Safety lock indicator lamp h Safety lock sensor switch i Hob ON/OFF sensor switch 5 Guide to the appliance KM 5733 abc Cooking zones e Cooking zone controls and displays (see "Cooking zone controls and displays") f Timer control and display (see "Timer control and display") g Safety lock indicator lamp h Safety lock sensor switch i Hob ON/OFF sensor switch 6 Guide to the appliance KM 5752 / KM 5757 abcd Cooking zones e Cooking zone controls and displays (see "Cooking zone controls and displays") f Timer control and display (see "Timer control and display") g Safety lock indicator lamp h Safety lock sensor switch i Hob ON/OFF sensor switch 7 Guide to the appliance KM 5753 abcd Cooking zones e Cooking zone controls and displays (see "Cooking zone controls and displays") f Timer control and display (see "Timer control and display") g Safety lock indicator lamp h Safety lock sensor switch i Hob ON/OFF sensor switch 8 Guide to the appliance KM 5755 abcd Cooking zones e Cooking zone controls and displays (see "Cooking zone controls and displays") f Timer control and display (see "Timer control and display") g Safety lock indicator lamp h Safety lock sensor switch i Hob ON/OFF sensor switch 9 Guide to the appliance KM 5775 abcd Cooking zones e Cooking zone controls and displays (see "Cooking zone controls and displays") f Timer control and display (see "Timer control and display") g Safety lock indicator lamp h Safety lock sensor switch i Hob ON/OFF sensor switch 10 Guide to the appliance Cooking zone sensors and displays j Displays: 0 = 1 to 9 = # = ß = F A P0 etc. = = = = Cooking zone ready for use Power settings (for switched on hob) Residual heat No pan on cooking zone or pan unsuitable (see "Induction") Fault (see "Safety switch-off") Auto heat-up when the power setting range has been extended Programme (see "Programming") Status (see "Programming") k Indicator lamp for Auto heat-up or extended power setting (see "Programming"), e. g. the front left cooking zone l Indicator lamp for booster m Sensor switch for booster n Power setting sensor switches 11 Guide to the appliance Timer control and display o Sensor switch for activating the timer, switching between functions and selecting automatic switch-off for a cooking zone. [. . . ] The residual heat indicator will appear in the display of any cooking zone which is still hot. 33 Safety features Safety lock Keep children away from the hob for their own safety. Your appliance is equipped with a safety lock to prevent the hob and the cooking zones being switched on or any settings being altered. The safety lock can be activated when the hob is switched off as well as when it is in use. If the safety lock is activated when the hob is switched off, then the hob cannot be switched on. If the safety lock is activated when the hob is in use: ­ The power levels for the cooking zones and the timer settings cannot be altered. ­ The cooking zones and hob can be switched off but once switched off cannot be switched on again. To activate the safety lock: ^ Touch the safety lock sensor $ until the relevant indicator lamp comes on. The lamp will come on again to show that the safety lock has been activated, if ­ you touch the safety lock $ sensor. To deactivate the safety lock: ^ Touch the safety lock sensor $ until the indicator lamp goes out. You can alter the setting from one finger to three finger operation (see "Programming - P4") to make it harder for children to operate the appliance. Please note that the safety lock will deactivate if there is a power cut. 34 Safety features Stop and Go Your appliance has a Stop and Go feature which, when activated, reduces the power of all cooking zones that have been switched on. This allows you to leave the hob unattended for a short time without any danger of pans boiling over or burning. If you wish to use this feature, you will need to alter the factory setting (see "Programming - P5"). To activate Stop and Go: ^ Touch the $ sensor until you hear two consecutive beeps. Be careful not to continue touching the $ sensor for too long, as this will activate the safety lock. The power of the cooking zone in use will be reduced to setting 1, and a 1 will appear in the corresponding cooking zone display. If automatic switch-off is programmed for a cooking zone, activating Stop and Go will interrupt the count down to the switch-off time. When Stop and Go is deactivated, the automatic switch-off programme time will continue to run without further interruption. If a minute minder time has been set, this will continue running and will not be affected by Stop and Go. To deactivate Stop and Go: ^ Touch the safety lock sensor $ until the indicator lamp goes out. The cooking zones will now run at the level that was previously set. 35 Safety features Safety switch-off Safety switch-off with an over-long cooking time Your hob is fitted with a safety switch-off feature in case you forget to switch it off yourself. If one of the cooking zones is heated for an unusually long period of time (see chart), and the power settings are not altered, the hob will switch itself off automatically and the appropriate residual heat indicator will appear. Power setting* Maximum operating time in hours 10 5 5 4 3 2 2 2 1 Safety switch-off if the sensors are covered Your hob will switch off automatically if one or several of the sensors remain covered for longer than 10 seconds, for example, by finger contact, food boiling over or by an object such as an oven glove or tea towel. [. . . ] The hob must be accessible from below for servicing purposes and to ensure that the seal around it is not dislodged. ­ directly into a suitable cut-out in a granite or marble worktop. ­ in a suitable cut-out in a tiled or solid wood worktop with a wooden support frame. The frame must be provided on site, and is not supplied with the appliance. 65 Installation Making the worktop cut-out and building in the hob Granite and marble worktops ^ Make the worktop cut-out as shown in the drawings. [. . . ]