User manual RICOH GP-1

[. . . ] Read this manual thoroughly before use and keep it handy when using the product. It can be used to record GPS data (longitude and latitude) and compass headings in photographs taken while it is connected to a G700SE. Tightening screws with the short shaft of the Allen key inserted in the heads could strip the receiving threads. [. . . ] Do not touch the internal components of the equipment if they become exposed as a result of being dropped or damaged. Cease use immediately and take the product to the point of purchase or to one of the RICOH service centers listed in the camera manual. Do not use the equipment near flammable gases, gasoline, benzene, thinner or similar substances to avoid the risk of explosion, fire or burns. Do not use it in a high temperature environment such as next to a fire or inside a car, or abandon it. GPS data are shown in the camera picture display and can be recorded with photographs as they are taken. Radio-frequency interference emitted by this device could cause accidents. Follow the directions of hospital staff when using this device in the vicinity of medical equipment. GPS data are not recorded with photographs taken while GPS data are being updated. Specifications Supported cameras GPS Receiver Acquisition times (*1) Update rate Data format Position accuracy (*1) RICOH G700SE Maximum number of satellites tracked: 48 Cold start: Approximately 40 s Hot start: Approximately 5 s 1s NMEA 0183 2D RMS Approximately 5 m Keep out of reach of children. notes on GPS Devices · Local geographic and atmospheric conditions that block, reflect, or otherwise interfere with GPS signals may prevent or delay the acquisition of GPS data. The device may be slow to acquire GPS data if it has not been used for some time or has been moved a great distance since last use. ⷠDevices that produce or block magnetic fields may interfere with the compass. precautions for Use · Do not drop or subject to strong physical shocks or vibration. Rapid changes in temperature could cause condensation inside the device, resulting in rust or mold. ⷠDo not use in areas exposed to powerful magnetic fields or electromagnetic radiation. Do not use the device with coverings made of metal or other substances that block radio waves or magnetic fields and interfere with the acquisition of GPS and compass data. [. . . ] Using the Allen key, remove the two screws holding the camera side cover (a) in place. Insert the connector on the GP-1 (b) into the connector on the camera with the status lamp (c) at the rear of the camera (Step 2). 3 Attach the GP-1 to the camera using the two screws (d) supplied Insert the long shaft of the Allen key into the head of the screw and rotate the short shaft by hand to tighten the two screws (Step 3). [. . . ]