User manual SANYO SCX1000P

[. . . ] - Place the charger on the wall mounting bracket (1) and push the charger downwards to fix it (2) (Fig. - Attach the nozzle & stick holder to the wall mounting bracket (SCX1000P only). - Screw the nozzle & stick holder to the wall with the screws supplied with the appliance. 2 To use the charger without attaching it to the wall: Place the charger on a level and horizontal surface. [. . . ] Charging the appliance Caution: Make sure the appliance is switched off when you charge it. Charge the appliance for at least 18 hours before you use it for the first time. Tip: If you are not going to use the appliance for a longer period of time, remove the adapter from the wall socket to save energy. Note:The charging light stays on as long as the appliance is placed on the charger and the adapter is in the wall socket. 1 Charge the appliance in one of the following two ways: Insert the small plug into the charger, insert the adapter into the wall socket, and place the appliance on the charger (Fig. - Insert the small plug into the charging socket of the appliance and insert the adapter into the wall socket (Fig. , The charging light on the appliance goes on to indicate that the appliance is charging (Fig. Note:The charging light does not give any information about the charge level of the built-in battery pack. 11) 3 Leave the adapter in the wall socket and always put the vacuum cleaner back onto the charger after use, even if the battery pack is still almost fully charged. Tools This appliance comes with the following tools: 1 Brush tool for cleaning delicate surfaces 2 Crevice tool for cleaning hard-to-reach places 3 Bendable crevice tool for cleaning at an angle (FC6093/6091 only) 1 Take the tool you want to use. Car cord (FC6093 only) With the car cord, you can connect the vacuum cleaner to the cigarette lighter socket in your car. , If necessary, you can clean the outer filter and the inner HEPA filter in cold or lukewarm water. 8 Place the outer filter back onto the filter holder and turn it clockwise to fasten it (Fig. Never put the filter unit back into the dust compartment when the outer filter and inner filter are still wet. 10 To clean the detachable nozzle, press the nozzle release button to remove the detachable nozzle from the appliance (Fig. , Both the nozzle insert and the detachable nozzle can be cleaned in warm water with some washing-up liquid or in the dishwasher. Make sure the nozzle insert and the detachable nozzle are dry before you reattach them to the appliance. 12 Reattach the dust compartment to the body of the vacuum cleaner (`click'). Replacement Replace the inner HEPA filter if it can no longer be cleaned properly (usually after it has been cleaned about 50 times). 3 Gently turn the inner HEPA filter anticlockwise (1) and remove it from the filter holder (2) (Fig. 4 Place a new inner HEPA filter on the filter holder (1) and turn the HEPA filter clockwise to fix it. 5 Place the outer filter back onto the filter holder (1) and turn the outer filter clockwise to fix it (2) (Fig. [. . . ] Environment Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. The built-in rechargeable battery pack contains substances that may pollute the environment. Always remove the battery pack before you discard and hand in the appliance at an official collection point. dispose of the battery pack at an official collection point for batteries. [. . . ]