User manual SEVERIN BA 3243

[. . . ] Always place the appliance on a flat, level and heat-resistant surface during operation. Do not position the appliance on or near hot surfaces or open flames such as hot-plates or gas flames. Always remove the plug from the wall socket - after use, - in case of any malfunction, - before cleaning the appliance. When removing the plug from the wall socket, never pull on the power cord; always grip the plug itself. [. . . ] — Laundry to be ironed should be sorted according to the fabric ironing temperature. — When ironing highly sensitive fabrics, or if you are not sure about the fabrics, you may carefully test-iron at a non-visible point, e. — If the laundry is being dried in a dryer before ironing, the temperature should be adjusted to “iron dry”. This will result in the removal of possible dust 9 Anti-scale filter A special filter in the generator reservoir softens the water and reduces the build-up of lime deposits in the sole plate. Filling with water Fill the water reservoir before using the steam function or the spray nozzle. - This steam iron is to a large extent resistant to hard water (up to 15º dH). Although normal tap water may be used, it is advisable to use distilled, demineralised or decalcified water. Should you be unsure about the hardness of the water in your area, please enquire of the relevant local authority department. — To prevent water from dripping from the sole plate, ensure that the steam control button is closed. It should be opened only once the temperature level required for steam ironing (as indicated on the temperature control knob) has been particles from the soleplate and subsequently lessen the smell typically encountered when first switching on. The temperature level for steam ironing is indicated on the temperature control knob. - After filling the reservoir with water, place the steam iron upright on its base stand and insert the plug into the wall socket. - Set the temperature control knob to the required ironing temperature as indicated by the ironing symbols. The lamp will go out once the required ironing temperature is reached. — Before ironing any fabrics, the soleplate should be cleaned by passing it over an old, clean cotton cloth, while using the steam jet function; this helps to flush out any dirt residues or lint particles trapped inside the openings in the soleplate. — The steam output can be adjusted with the steam control button or completely switched off for dry ironing. Should there be water left in the reservoir, the steam jet function may also be used when dry-ironing at higher temperature settings. — Place the steam iron upright on its base stand after use and remove the plug from the wall socket. Steam Jet When the steam jet button is depressed, an additional hot steam jet is emitted from the soleplate. This function can be very useful when the regular amount of steam emitted is not sufficient to remove stubborn creases or when ironing difficult or thick fabrics. [. . . ] - Pour any remaining water out of the reservoir through the water fill hole. — To avoid damage to the soleplate, store the steam iron in upright position on its base stand. Disposal Do not dispose of old or defective appliances in domestic garbage; this should only be done through public collection points. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. [. . . ]