User manual SEVERIN KS 9874

[. . . ] Remplacez l’ampoule par une ampoule de même type, de 15 W et de support E14. Enlevez le support du bas (7) et positionnez à sa place l’autre support du bas (2) ainsi que les rondelles sur l’essieu et le joint en plastique. If instructions are not followed, there is a risk of injury, damage to the appliance, and loss of the right to free warranty service. We recommend to keep the Instruction manual the whole time you have the appliance. [. . . ] Unplug the appliance from the mains by pulling the plug out of the electricity supply socket. Squeeze the sides of the light fixture cover 1 to unhook the cover fasteners A and pull downward. Replace the light bulb with the same 15 W type light bulb with the E14 lamp holder. After changing the light bulb, put the cover fastener hook in place B and then press upward until it’s fixing in place. 32 GB Changing the opening direction of the doors It is recommended that changing the opening direction of the doors should be done with a helper. When changing the opening direction of the doors, YOU CAN NOT lay the refrigerator horizontally. Turn off the appliance and pull the plug out of the electricity supply socket. Remove the covers c from the body of the refrigerator and of the inner side of the door. Also remove the upper bracket 6 together with the nut and washers and the spacer under the bracket. On the other side of the door, attach the stopper intended for doors that open on the left (you will find it in the packet). Remove the middle bracket 4 together with the washers on the axle and the plastic spacer. Remove the bottom bracket 2 together with the washers on the axle and the plastic spacer. Unscrew the axle with the washers and screw it into the aperture provided on the other side. Remove the bottom bracket 7 and in its place attach the other bottom bracket 2 together with the washers on the axle and the plastic spacer. Remove the covers 8 from the partition separating the refrigeration compartment from the freezer compartment and place them in the apertures on the other side. Remove the covers 9 from the doors of the refrigeration compartment and the freezer compartment and place them in the apertures on the other side. Turn bracket 4 around 180° together with the washers on the axle and the plastic spacer, transferring the washers to the axle on the other side of the bracket. Once the bracket is attached to the freezer compartment door, fix it in place on the other side of the refrigerator. Turn the bracket 6 around 180° together with the washers on the axle and the plastic spacer. Remove the axle and the washers and reattach them on the other side of the bracket. Once the bracket 6 is attached to the refrigeration compartment door, fix it in place on the other side of the refrigerator in the uppermost apertures. Place the stoppers into the remaining apertures in the door, and put the screw caps in place. [. . . ]  Products will freeze more quickly if they are divided up and packed in small portions. As the appliance operates and goes through the freezing cycle, various noises will be emitted.  As the refrigerant circulates around the refrigeration system, it causes sounds like murmuring, bubbling, or rustling.  Louder sounds like popping or clicking may be heard for a short time as the refrigerator’s compressor switches on. [. . . ]