User manual SIEMENS SN64E000EU

[. . . ] 9000 405 914 (8812-1) en Instructions for use en Index 4 4 4 4 4 4 4 5 5 5 5 6 6 6 7 7 7 8 8 8 9 9 9 9 9 9 10 10 10 10 11 11 12 13 14 14 14 15 15 15 Hygiene . 15 15 15 15 15 15 15 16 16 16 16 17 17 17 17 17 18 18 19 19 19 19 20 21 22 22 22 23 23 23 23 24 24 24 24 25 25 25 Safety instructions . . en Safety instructions Delivery Check the packaging and dishwasher immediately for damage caused in transit. Please dispose of the packaging material in an environmentally friendly manner. [. . . ] Keep pressing the Preselected starting time button 2 until the appropriate display 3 h, 6 h or 9 h is lit. To delete the preselected starting time, keep pressing the Preselected starting time button 2 until none of the displays 3 h, 6 h or 9 h is lit. You can change your programme selection at any time until the programme starts. Change the setting as follows: ress button < 5 until the required setting has been selected. Close the door. Switching off the appliance Short time after the end of the programme: Open the door. Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. End of programme The programme has ended when the End display 8 is lit. Hold down button > 6 and press Start button 9 until the End display 8 and salt refill indicator 11 flash. Keep pressing button > 6 until the salt refill indicator 11 and rinse aid refill indicator 10 flash. The refill indicator 11 flashes and the displays 10 and A are B lit (= setting 2). The set buzzer volume can be heard. Interrupting the programme Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. Close the door. 16 en Terminating the programme (Reset) Open the door. Close the door. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine Check spray arm for grease and limescale deposits. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. Health hazard! Changing the programme When the START button 9 has been pressed, the programme cannot be changed. [. . . ] Drain the appliance according to the following steps: Turn on the tap. (This prevents residual water from running into the machine control and damaging the programme sequence). Removing the appliance Also observe the sequence of worksteps here. Pull out the appliance, carefully pulling the hose behind. Protection against frost If the appliance is in a room where there is a risk of frost (e. g. Turn off the tap, disconnect supply hose and drain water. 24 en Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. [. . . ]