User manual SMEG SI3633B

[. . . ] -- We thank you for your help in protecting the environment. Residual heat A cooking zone can remain hot for several minutes after use. Avoid touching the hot areas during this time. Child safety Your hob has a child safety feature which locks it when it is off or during cooking (see section: use of child safety). Do not forget to unlock before using again. For users with heart pacemakers and active implants. The functioning of the hob conforms to current electromagnetic interference standards and thus is in total compliance with legal requirements (2004/108/CE directives). [. . . ] Only glass, terra cotta, aluminium without a special finish on the bottom, copper and some non-magnetic stainless steels do not work with induction cooking. The heat will be distributed better and cooking will be more uniform. By choosing cookware that displays this logo on its bottom or on its packaging, you can be certain that it is perfectly compatible with your hob under normal operating conditions. 21 EN 2 / USING YOUR APPLIANCE DESCRIPTION OF THE CONTROLS SETTING THE TIMER There is a rotating timer for each cooking zone. C Timer button. B C SWITCHING ON Press the start/stop button for the cooking zone you want to use. A flashing 0 display and a beep indicates that the cooking zone is on. If you do not select a power level, the cooking zone will automatically switch off. STOP Hold down the start/stop button for the cooking zone used. ADJUSTING THE POWER LEVEL Press the "+" button to increase your power level from 1 to P (maximum power) and the "-" button to reduce it. When the appliance is switched on, you can move directly to maximum power "P" by pressing the "-" button. By pressing the button repeatedly you can select the cooking zone to which you wish to apply the timer. To use the timer: - Switch on the cooking zone and adjust the power level. - Press + or - until you reach the desired setting for your cooking time. The timer starts counting only if the cooking zone is covered with an item of cookware. When the cooking is finished the zone switches off, the timer indicates 0, and you are notified by a sound signal. Clean the hob or remove the object, then begin cooking again. Auto-Stop system If you forget to turn off a preparation, your cooking hob has an "Auto-Stop system" safety function which automatically turns off the forgotten cooking zone after a predefined time (between 1 and 10 hours, depending on the power used). If this safety function is activated, the disconnection of the cooking zone is signalled by A A the display "AS" or "A" in the control zone and a beep is emitted for approximately 2 minutes. A double beep will confirm your action. "Small Items" safety A small object (such as a fork, a spoon, a ring, etc. ) left alone on the hob is not detected as a piece of cookware. The display flashes and no heat is produced. Warning Several small objects together on a cooking zone may be detected as cookware. If the display remains on: power may be supplied and the objects may be heated. 24 3 / GENERAL MAINTENANCE OF YOUR APPLIANCE EN CARING FOR YOUR APPLIANCE . [. . . ] The hob is not working and another The electronic board is funcmessage is displayed. See chapter on using the child safety system. While in use YOU OBSERVE THAT: POSSIBLE CAUSES: WHAT SHOULD YOU DO? Clean the hob or remove the object, then begin cooking again. The hob has stopped operating and is There was an overflow or an beeping approximately every 10 sec- object is in contact with the onds and a or F7 is displayed. [. . . ]