User manual SOLAC D212

[. . . ] Hot wax hair removal has the advantage of reducing the rate of hair growth. Regrowth is therefore slower, with hair of a finer texture which tends to disappear. [. . . ] â· If the power cord is damaged, it should be replaced by the manufacturer or by your after-sales service shop or similar qualified personnel to prevent possible hazards. â· Remove all elements from the inside or outside of the appliance used for protection during transport or for sales promotions, such as paper or plastic bags, plastic sheets, cardboard and stickers. Do not use near bathtubs, sinks, showers or other recipients containing water. The appliance must be connected to a power socket with a suitable ground connection. do not use on sensitive areas such as eyebrows , moles , warts , open wounds , cuts , burns , etc. IMPORTANT: When you want to dispose of the appliance, NEVER throw it in the rubbish bin. Take it to your nearest CLEAN POINT or the waste collection centre closest to your home for processing. I To obtain an excellent result, hair should be at least 2 to 3 millimetres in length and skin should be clean without cream or talc. I After a few minutes the light will come on again and the wax should be at a suitable temperature for hair removal. 7 Using the spatula place a little wax on the back of your hand to test the temperature. 8 Run your hand along your legs using an upward motion to flatten out the hairs. 9 Using the large spatula, spread out the wax in strips of approximately 6 cm in length and 3 cm in width. [. . . ] Z It is not advisable to remove hair from the armpits and eyebrows at home. 2 If occasionally, a little wax has run onto the outer surface, you can easily remove it with your finger nail. [. . . ]