User manual TP-LINK TL-PA201

[. . . ] TL-PA201 200Mbps Powerline Ethernet Adapter Rev: 1. 0. 0 1910010103 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. http://www. tp-link. com I FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] 2 Connect the provided Ethernet (RJ-45) cable to the Ethernet Powerline Adapter's Ethernet port. 3 Connect the other end of the Ethernet (RJ-45) cable to an available Ethernet port of your ADSL broadband Router. 4 Plug the Ethernet Powerline Adapter into a wall socket next to the computer. 6 Check and confirm that the Power, Powerline and Ethernet LEDs on the Ethernet Powerline Adapter are ON. Click and select the local device shown on the screen then click "Connect" tab to manage the Ethernet Powerline Adapter. The status message will be shown above the "Connect" button indicates that your PC is connected to the same device. Once the chosen Ethernet Powerline Adapter is properly connected, this Management Utility will automatically scan the power line periodically for any other existing powerline devices. "x" Powerline Devices detected: This display all the Ethernet Powerline Adapter found on the current logical network. "x" shows the number of remote Ethernet Powerline Adapter discovered by this Management Utility. Network Type: Displayed the type of logical network: "Public" or "Private". One may redefine or change the name by clicking on the name and editing in place or by clicking the "Rename" button. Password: Shows the current password of the Ethernet Powerline Adapter. Quality: Shows the quality of the Ethernet Powerline Adapter connection. Rate (Mbps): Shows the current transmission rate of the selected Ethernet Powerline Adapter. Rename: Click to change the name of the selected Ethernet Powerline Adapter. Enter Password: Shows the supplied Ethernet Powerline Adapter's password (Initially left blank). To set the Ethernet Powerline Adapter password (Which is required when creating a private network), click and select the device shown in the lower panel and click on the "Enter Password" button. Add: Click this button to add a remote Ethernet Powerline Adapter to your network that is not on the lower panel displayed list. You will advice to locate the passwords for all Ethernet Powerline Adapter 9 TL-PA201 200Mbps Ethernet Powerline Adapter you wish to manage and add them to the local logical network by clicking the "Add" button. Scan: Click the "Scan" button to perform an immediate search of the Ethernet Powerline Adapter connected to the computer. The Management Utility will automatically perform the scanning process and update the display every few seconds by default. 4. 1. 1 Rename This Management Utility allows you to change the name of the listed Ethernet Powerline Adapter. [. . . ] Press the Pair button of Powerline adapter A for 2 seconds, the Power LED will start blinking. Press the Pair button of Powerline adapter B for 2 seconds, the Power LED will start blinking (This must be done within 120 seconds after pressing the Pair button of Powerline adapter A. ) Wait for about 60 seconds while your Powerline adapter A and B are connecting. The Power LED on both adapters will stop blinking and light up when the connection is made. 17 TL-PA201 200Mbps Ethernet Powerline Adapter Join an existing Powerline AV Network: Step 1. Press and hold the Pair button on Powerline adapter C for more than 10 seconds until both the Powerline and Power LED are off, then release the button and the Power LED will start blinking. [. . . ]