User manual TP-LINK TL-R860

[. . . ] TL-R860 Cable/DSL Router Rev: 1. 0. 2 1910010010 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. Other brands and product names are http://www. tp-link. com FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Protocol - The protocol used for this application, either TCP, UDP, or All (all protocols supported by the router). If the Common Service Port list does not have the service that you want to use, type the number of the service port or service port range in the Service Port box. Type the IP Address of the computer in the Server IP Address box. - 23 - 3. TL-R860 4. 6. Cable/DSL Router User Guide Select the protocol used for this application, either TCP or UDP, or All. Click the Save button. Figure 4-18 Add or Modify a Virtual Server Entry Note: It is possible that you have a computer or server that has more than one type of available service. If so, select another service, and enter the same IP Address for that computer or server. Click the Save button. Click the Enable All button to make all entries enabled Click the Disabled All button to make all entries disabled. Click the Delete All button to delete all entries Click the Next button to go to the next page and Click the Previous button to return the previous page. Note: If you set the virtual server of service port as 80, you must set the Web management port on Security ­> Remote Management page to be any value except 80 such as 8080. Or else there will be a conflict to disable the virtual server. 4. 6. 2 Port Triggering Some applications require multiple connections, like Internet games, video conferencing, Internet calling and so on. Port Triggering is used for some of these applications that can work with an NAT router. You can set up Port Triggering on this page shown in Figure 4-19: - 24 - TL-R860 Cable/DSL Router User Guide Figure 4-19 Port Triggering Once configured, operation is as follows: 1. A local host makes an outgoing connection using a destination port number defined in the Trigger Port field. The router records this connection, opens the incoming port or ports associated with this entry in the Port Triggering table, and associates them with the local host. When necessary the external host will be able to connect to the local host using one of the ports defined in the Incoming Ports field. An outgoing connection using this port will "Trigger" this rule. Trigger Protocol - The protocol used for Trigger Ports, either TCP, UDP, or All (all protocols supported by the router). Incoming Ports Range - The port or port range used by the remote system when it responds to the outgoing request. A response using one of these ports will be forwarded to the PC that triggered this rule. Incoming Protocol - The protocol used for Incoming Ports Range, either TCP or UDP, or ALL (all protocols supported by the router). To add a new rule, enter the following data on the Port Triggering screen. Enter a port number used by the application when it generates an outgoing request. [. . . ] To change the WEB management port number: Login to the router, click the "Security" menu on the left of your browser, and click "Remote Management" submenu. On the "Remote Management" page, type a port number except 80, such as 88, into the "Web Management Port" field. Click "Save" and reboot the router. 2) Figure A-7 Note: Remote Management If the above configuration takes effect, to configure to the router by typing http://192. 168. 1. 1:88 (the router's LAN IP address: Web Management Port) in the address field of the web browser. 3) Login to the router, click the "Forwarding" menu on the left of your browser, and click the "Virtual Servers" submenu. [. . . ]