User manual TP-LINK TL-SF1016DS

[. . . ] These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. [. . . ] The IP Camera needs to be rebooted after it finishes changing the network completely. The IP Camera with Intelligent IP Installer can't be founded after enabling the PPPoE and rebooting. 6. 3. 3 DDNS (Dynamic DNS) Choose menu "Dynamic DNS", you can configure the Dynamic DNS function. The IP Camera offers the DDNS (Dynamic Domain Name System) feature, which allows the hosting of a website, FTP server, or e-mail server with a fixed domain name (named by yourself) and a dynamic IP address, and then your friends can connect to your server by entering your domain name no matter what your IP address is. Before using this feature, you need to sign up for DDNS service providers such as www. dyndns. org, or www. no-ip. com. The Dynamic DNS client service provider will give you a password or key. 26 Server name: Choose the DDNS Server from the list. User ID: Enter the user ID for authentication necessary for DDNS connections. Password: Enter the password for authentication necessary for DDNS connections. Log in with new account and click Account My Hosts Add Host Services. 28 4. Type your DDNS User ID, Password and Host name in Setting Network DDNS. After completing setting, reboot IP Camera. 6. 3. 4 UPnP (Universal Plug and Play) Choose menu "NetworkUPnP", you can view the information about UPnP (Universal Plug and Play) in the screen as shown in the following figure. The UPnP feature allows the devices, such as Internet computers, to access the local host resources or devices as needed. This setting is necessary when the SMTP server which sends e-mails performs authentication using the POP user account. User name, Password: Type the user name and Password of the user who has the mail account. This setting is necessary when the SMTP server which sends e-mails performs authentication. Recipient e-mail address: Type the recipient e-Mail address up to 64 characters. Administrator e-mail address: Type the Administrator e-Mail address up to 64 characters. This address is used for reply mail and sending system messages from the SMTP server. Default value provides network information including IP, Port, MAC, Model, Firmware Version and Web Version. 6. 4 Security Click Security to display the submenus including Account and HTTPS. 34 6. 4. 1 Account The device default account and password setting is "admin / admin". That means everyone who knows IP address can access the device including all configuration. Therefore, it is necessary to assign a password if the device is intended to be accessed by others. User name: Set a user name between 4-16 characters. The Operator mode can not only view the Live View but also control the PTZ (apply in speed dome). Viewer Authentication: Allows all viewers directly access to Live View. 35 6. 4. 2 HTTPS HTTPS is a URL scheme used to indicate a secure HTTP connection. [. . . ] (Please go to "Setting Advance Motion detection Setting") For more details, you can check Section 7. 5. Motion Detection works only when the MPEG4 function is On. 52 Parameter: the parameter of CGI (defined in Setting Advance HTTP event General URL) is from your target device. If your target device didn't support the parameter of message, you can't see the message. Effective period: Set the period when the periodical sending is effective. [. . . ]