User manual UNIDEN XC3545
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual UNIDEN XC3545. We hope that this UNIDEN XC3545 user guide will be useful to you.
Manual abstract: user guide UNIDEN XC3545
Detailed instructions for use are in the User's Guide.
[. . . ] 54 1
Important Safety Instructions
When using your telephone equipment, these basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons: 1. Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect the product from overheating, these openings must not be blocked or covered. [. . . ] Check with your local phone company if you are not sure whether your system is Tone or Pulse dialing.
Adjusting Ringer/Volume Controls
The Handset and Base of the :+!#"# have controls to adjust their volumes.
Handset Volume Controls
To adjust the ringer volume of your Handset, press when the phone is not in use.
L
OPER
0
TONE
MEM 1 2 3
FLASH VOLUME
INT'C R. TONE R. VOL RDL/P
Handset Ringer Volume Control You can also select one of two different ringer tones for the Handset. Press to select a different ringer tone when the phone is not in use.
O
OPER
0
TONE
MEM 1 2 3
FLASH VOLUME
INT'C R. TONE R. VOL RDL/P
Handset Ringer Tone Select Button
27
To adjust the receiver volume, press while you are on a call.
V
OPER
0
TONE MEM
1 2 3
FLASH VOLUME
INT'C R. TONE R. VOL RDL/P
Handset Receiver Volume Select Button
Base Volume Controls
To adjust the Base Unit ringer volume, move the RING-OFF LO HI switch to the desired setting.
RING-OFF LO HI
To adjust the Base speaker volume, slide the VOLUME control to the desired setting.
VOLUME
VOLUME
VOLUME
28
Automatic Digital Code Security
Many cordless telephones operate similarly and on the same frequency. Without digital code security, another Handset could make calls using your Base Unit and telephone line. To avoid unauthorized calls on your phone, a Digital Code feature was added to the:+!#"#. To reset the Digital Code, be sure the Handset is on the Base, then: 1. Press on the Base Unit.
Note: The phone begins ringing when is pressed.
2. (The ringing will stop. )
I
I
29
3.
The CHARGE LED will blink to indicate that the Digital Security Code is set to one of the more than 65, 000 codes.
ABC IN USE CHARGE DEF
1
GHI
2
JKL
3
MNO
RDL/P
1
4
FLASH 2 PRS
5
TUV
6
WXY
7
MEM 3 TONE
8
OPER
9
*
Extend·A·Phone
HQ SERIES
0
SPEAKER
MUTE
INT'COM
PAGE / FIND
If the Base Unit loses power while the Handset is off the Base, the Digital Code may be erased. Remove the Handset from the Base Unit (if it is on the Base Unit).
30
2.
Restore power to the Base Unit, and place the Handset back on the Base Unit. The CHARGE LED will blink to indicate that the Digital Security Code is set.
ABC IN USE CHARGE DEF
3.
1
GHI
2
JKL
3
MNO
RDL/P
1
4
FLASH 2 PRS
5
TUV
6
WXY
7
MEM 3 TONE
8
OPER
9
*
Extend·A·Phone
HQ SERIES
0
SPEAKER
MUTE
INT'COM
PAGE / FIND
31
Using your XC3545
The :+!#"# has dual keypads: one in the Handset, and one on the Base Unit. This is like having two phones because most operations can be performed using either the Handset or the Base Units.
Making and Receiving Calls
The following features of your :+!#"# phone are different depending on the Handset's location when you make or receive a call.
HANDSET BASE UNIT ON BASE UNIT ANSWER CALL OFF BASE UNIT
Pick up Handset (AutoTalk)
PressT
1) PressK The speaker LED lights. 1) PressK 2) Listen for dial tone 3) Dial number
MAKE CALL
1) Pick up Handset 2) PressT 3) Listen for dial tone 4) Dial number
1) PressT 2) Listen for dial tone 3) Dial number
HANG UP
PressT -- OR -- Return Handset to Base (AutoStandby) 1) Pick up Handset 2) PressT 3) Listen for dial tone 4) PressR 1) PressT 2) Listen for dial tone 3) PressR
PressK The speaker LED goes off.
REDIAL
Note: Sometimes when you press to hang up the phone, you may get an error tone and the phone will not disconnect. If this happens, place the Handset on the Base Unit or press again while holding the Handset close to the Base Unit.
32
TT
1) PressK The speaker LED lights. 2) Listen for dial tone 3) PressR
Changing Channels, Hold, Mute, and Flash
To change channels, place a call on hold, mute a call, or access call waiting while on the phone, follow these steps:
CHANGING CHANNELS
Press Note: Change channels to help eliminate background noise. 1) Press Note: The phone will begin to ring, and the TALK/BATT LOW LED will blink, indicating the call is on hold. 2) Press to continue call.
PLACING A CALL ON HOLD
E J T
HANDSET
BASE
Note: You must use the Handset to change channels.
1) Press Note: The phone will begin to ring, and the IN USE LED will blink, indicating the call is on hold. Note: You will be able to hear the caller, but they will not hear you. Suppose the call waiting tone sounds, press to accept the waiting call. -- OR --
MUTE
Note: You can only mute a call while using the Base Unit.
I IK U F
If the call waiting tone sounds, press to accept the waiting call.
FLASH
-- OR --
If you have finished a call and want to make another call, press to hang up and get a dial tone.
F F
F
If you have finished a call and want to make another call, press to hang up and get a dial tone.
33
Using Page/Intercom
The 2-Way Page/Intercom feature allows you to communicate between the Base Unit and Handset. To use this feature remember the following: · · The RING ON/BATT SAVE switch on the Handset must be in the RING ON position. The BASE UNIT RINGER switch must be set to either LO or HI.
Note: If you are on a call while using the Handset and you page the Base Unit, the Base Unit will ring even when the Base ringer switch is set to the OFF position.
2-Way Paging
Paging the Base Unit
1. Press Handset.
J
J K
on
Note: If there is no answer, press again to cancel.
2. PressT on the Handset orI on the Base.
3
1
D
2
34
Paging the Handset
1. [. . . ] (including battery) BT-185 Capacity 270 mAh, 3. 6V Talk Mode 6 hours Standby Mode 7 days Battery Save Mode 5 weeks 48. 76 to 49. 99 MHz (25 Channels) 43. 72 to 46. 97 MHz (25 Channels) 120V AC 60 Hz 7 3 in (W) x 5 17 in (D) x 1 7 in (H) 4 32 8 Approx. Crystal controlled transmission FM 10° to 50° C
Specifications, Features, and availability of Optional Accessories are all subject to change without prior notice.
54
®
XC3545
Cordless Telephone
D
UDZZ01323ZZ
Operating Guide
PRECAUTIONS
Before you read anything else, please observe the following:
WARNING!
Uniden America Corporation DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOT expose this unit to rain or moisture.
RECHARGEABLE NICKEL-CADMIUM BATTERY WARNING
This equipment contains a Rechargeable Nickel-Cadmium Battery. Cadmium is a chemical known to the State of California to cause cancer. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE UNIDEN XC3545
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual UNIDEN XC3545 will begin.