User manual X10 EASYTOUCH 35

[. . . ] General Safety Note_______________________________________________________3 Introduction _____________________________________________________________4 Installing the batteries _____________________________________________________5 Description of the ET35 "rubber" keys _______________________________________5 Description of the ET35 "Touchscreen" keys __________________________________6 Programming using 3 Digit Code Tables for the TV, VCR, CD, SAT, CBL, DVD, AUDIO and Marmitek X-10 Home Automation keys _____8 Programming using Brand search method ____________________________________9 Programming using Code search method____________________________________11 Identifying codes found using the search procedures __________________________12 Programming a Macro____________________________________________________13 Channel toggle key ______________________________________________________15 Setting key labels ________________________________________________________17 Code learning___________________________________________________________18 Marmitek X-10 Home Automation _________________________________________20 14. Programming the Home Automation IR/RF mode ________________________21 Extra functions __________________________________________________________23 Controlling your equipment from any place in your home______________________24 Problems and troubleshooting _____________________________________________25 Technical manipulation of the product or any changes to the product are forbidden, due to security and approval issues. Strong mechanical tear and wear high temperature strong vibrations high humidity For questions not covered from the user guide please visit www. To insure a proper set up please read the manual and safety notes carefully. [. . . ] Press and release the Touchscreen "EXIT" key to return to normal operation. The Home Theatre Macro function allows you to store several sequences of IR Commands (key presses). A total number of 20 keystrokes can be stored under each of the 9 available Macro keys. Press and hold Setup key until the LED remains on (occurring after approximately 2-3 seconds) and the display shows the Main Setup Screen. Press and release the remote keys (maximum of 20) that are required to be stored in the exact order that they should be transmitted. Use the Touchscreen "SCREEN" key to toggle the screen keys displayed and use the Mode keys for any Mode changes. Note - if you program the maximum of 20 keys, then the Macro will be automatically stored on the 20th keypress. Press and release the Touchscreen "EXIT" key to return to normal operation. "SHIFTED" key commands are not allowed to be included in Macros. It may be necessary to have "delays" included in the Macro sequence (e. Press and hold the Setup key until the LED remains on (occurring after approximately 2-3 seconds) and the display shows Main Setup Screen. The Channel-Toggle "P<P" key is a special form of Macro key. The feature allows you to program in two specific channels and switch between them with a single key-press. Each set of data can be up to 4 key-presses and must be a minimum of 2. The following keystrokes can be any other key (except for Mode, Macro, Setup and Screen) although in practice, these keys will usually be digit keys. Press and hold Setup key until the LED remains on (occurring after approximately 2-3 seconds) and display shows the Main Setup Screen. First Setup keypress takes you to the "Delay" screen and the second Setup press results in abort and exit. Use the "SCREEN" Key to toggle the screen keys displayed ­ this counts as a keypress. If less than 3 keys are required then press the Mode key and go directly to Step 7. To enter the second set of data, press and release desired Mode key (TV, VCR, SAT, etc. You can now press up to 3 keys (a minimum of 1 key must be pressed) for the second set of data. Use the "SCREEN" Key to toggle the screen keys displayed ­ this counts as a keypress. [. . . ] Press and hold Setup key until the LED remains on and display shows the Main Setup Screen. Press and hold the Setup key for approximately 5 seconds until the LED blinks on then turns off. When pressed, a Channel Up command for the Current Mode code is sent once every 3 seconds. Scanning will automatically time-out after 2 minutes if no key is pressed. [. . . ]