User manual X10 RC6500

[. . . ] RC6500 Installation and operating instructions The KR19A keychain remote turns on and off a light or appliance plugged into the TM751 Transceiver. It also lets you turn on and off two individually coded X10 Modules and brighten and dim lights connected to Lamp Modules and Wall Switch Modules (sold separately). [. . . ] If you want to control Modules 1 and 2 on Housecode A, that's it. If you want to change the Housecode: · Press and hold the first (top) ON button. 3 seconds later, the LED blinks the current setting: 1 blink for Housecode A, 2 blinks for B. . . . . · Press and release the first (top) ON button the appropriate number of times for the Housecode you want to set. If you do not follow this programming sequence, the LED will stay on for 1 second and your existing setting will not be changed. If you want to change the Unit Code for the top two buttons (the second pair of buttons are always one # higher than the top pair, i. e. 3 seconds later, the LED blinks the current setting: 1 blink for Unit Code 1, 2 blinks for 2, 16 blinks for 16. · Press and release the top OFF button the appropriate number of times for the Unit Code you want. If you do not follow this programming sequence, the LED will stay on for 1 second and your existing setting will not be changed. To change the battery: Pry the unit apart and fit a CR2025 Lithium 3V battery. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. Press to turn A1 ON. [. . . ] If service is required under this warranty: Call 1-800-442-5065, visit www. x10. com, or e-mail support@x10. com. For help or more information on setup, please visit: http://www. x10. com/support RC6500-10/02 [. . . ]