User manual X10 RC6600

[. . . ] RC6600 (KR22A + TM751) Installation and operating instructions The KR22A turns on or off a light or appliance plugged into the TM751. It also lets you turn on and off 4 individually coded X10 Modules and brighten and dim lights connected to Lamp Modules and Wall Switch Modules (sold separately). [. . . ] To change the Housecode · Press and hold the first (top) ON button. 3 seconds later, the LED blinks the current setting: 1 blink for Housecode A, 2 blinks for B. . . . . · Press and release the first (top) ON button the appropriate number of times for the Housecode you want to set. If you do not follow this programming sequence, the LED will stay on for 1 second and your existing setting will not be changed. To change the Unit Code for the first (top) two buttons (the next three buttons always run in sequence, i. e. if you set the first button to 6, the four buttons will control 6, 7, 8, and 9, etc. ). 3 seconds later, the LED blinks the current setting: 1 blink for Unit Code 1, 2 blinks for 2, 16 blinks for 16. · Press and release the top OFF button the appropriate number of times for the Unit Code you want. If you do not follow this programming sequence, the LED will stay on for 1 second and your existing setting will not be changed. To change the batteries: Pry the unit apart and fit two CR2016 Lithium 3V batteries. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. Press to turn A1 ON. [. . . ] Please visit www. x10. com/warranty to complete your on-line warranty registration. For help or more information on setup, please visit: www. x10. com/support RC6600-9/01 [. . . ]