User manual X10 RR501

[. . . ] Installation and operating instructions for RR501 Wireless remote controls such as the KR19A and HR12A send wireless Radio Frequency (RF) signals to the RR501 Transceiver. The RR501 then passes the signals onto your house wiring to control lights or appliances around your home. [. . . ] Press the corresponding ON or OFF button (1-8 or 9-16) on the remote control to turn X10 Modules on/off. You can also turn the light/appliance connected to the RR501 on and off from any X10 plug-in controller. Set the small slide switch on the RR501 to 1 or 9 for it to respond to either of those codes from an X10 controller. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. This equipment generates and uses radio frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturers instructions, it may cause interference to radio and television reception. It has been type tested and found to comply with the limits for remote control devices in accordance with the specifications in Sub-Parts B and C of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by unplugging the equipment, try to correct the interference by one or more of the following measures. · Reorient the antenna of the radio/TV experiencing the interference. · Plug the equipment into an outlet on a different electrical circuit from the radio/TV experiencing the interference. [. . . ] If service is required under this warranty: Call 1-800-442-5065, visit www. x10. com, or e-mail support@x10. com. For help or more information on setup, please visit: http://www. x10. com/support RR501-11/02 [. . . ]