User manual X10 SM10 DATASHEET

[. . . ] Universal Alarm Interface Benefits Connects to an existing system and turns on lights when tripped. [. . . ] In mode 3 the SM10 will turn ON any Module set to the same House Code and Unit Code as the SM10 when the system is activated and turns it OFF when the input contact is opened. Set the input switch to A for triggering the interface by a low voltage input (6-8 V AC, DC or audio), to B for triggering the interface by a dry contact closure. The SM10 has a test button which allows you to activate it whether or not it is connected to a system. The All light off button allows you to turn off anything which has been turned on by the interface. To install the SM10 (is expected to be installed inside the security controller panel) : · Connect the system output to the screw terminals. · Connect the flying lead to the 230V power supply, most likely at the 230V side of the transformer. [. . . ] · Trigger it from sensors such as a photo cell to turn on lights when it gets dark, from a motion detector to turn on lights when someone enters a room, from a microphone to turn on lights or appliance when a sound from an intruder is detected, from a moisture sensor to sound an alarm if your basement is flooded, from a garage door opener to turn on lights when you open your garage door, etc. [. . . ]