User manual YAMAHA AX-490
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual YAMAHA AX-490. We hope that this YAMAHA AX-490 user guide will be useful to you.
Manual abstract: user guide YAMAHA AX-490
Detailed instructions for use are in the User's Guide.
[. . . ] Quick stops, excessive force, and uneven surfaces may cause the unit and cart combination to overturn.
11 Power-Cord Protection Power-supply cords should be
routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit.
12 Cleaning The unit should be cleaned only as
recommended by the manufacturer.
13 Nonuse Periods The power cord of the unit should be
unplugged from the outlet when left unused for a long period of time.
14 Object and Liquid Entry Care should be taken so that
objects do not fall into and liquids are not spilled into the inside of the unit.
6
15 Damage Requiring Service The unit should be serviced
by qualified service personnel when:
6A A unit and cart combination should
A. Objects have fallen, or liquid has been spilled into the
unit; or
7
Wall or Ceiling Mounting The unit should be mounted to a wall or ceiling only as recommended by the manufacturer. Ventilation The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, the unit should not be situated on a bed, sofa, rug, or similar surface, that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. [. . . ] model)
GND
CD
TUNER
AC OUTLETS
TAPE PB TAPE 1 REC OUT
SWITCHED
SPEAKERS
l20V 60Hz l00W MAX. TOTAL
MAINS
TAPE PB PHONO TAPE 2 REC OUT PHONO
A
B
AUX
A OR B:6MIN. /SPEAKER A B:l2MIN. /SPEAKER
REMOTE CONTROL
OUTPUT
GND
To AC outlet AUDIO OUT LINE OUT LINE IN
Right Turntable Video cassette player, LD player, etc. Tape deck 2 Speakers B
Left
: Refer to "ABOUT THE OTHER REAR PANEL PARTS" on page 6.
AC OUTLETS (SWITCHED)
(U. S. A. , Canada, Europe and General models) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SWITCHED OUTLETS (U. K. and Australia models) . . . . . . . . . . . . . . . . . . 1 SWITCHED OUTLET Use these to connect the power cords from your components to this unit.
The power to the SWITCHED outlets is controlled by this unit's POWER switch or the provided remote control transmitter's POWER key. These outlets will supply power to any component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLETS is 100 watts.
5
CONNECTING SPEAKERS
Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and markings are observed. If these wires are reversed, the sound will be unnatural and will lack bass. q If you will use this unit with an external unit connected between the PRE OUT and MAIN IN terminals, make sure that the CD DIRECT AMP switch and the PURE DIRECT switch on the front panel are turned off. q If you will use this unit as a power amplifier, connect the outputs of an external control amplifier etc. In that case, this unit's controls will not function except the PHONES jack and the SPEAKERS switches, so use the controls on the external control amplifier to make volume adjustment etc.
q
6
OPERATIONS
AX-590
2
7 1, 6 4 7 3 7 1, 6 4 7 4
l2 l0 8 6 4 3 2
AX-490
2
3
Select the speakers to be used.
SPEAKERS A
ON
TO PLAY A SOURCE
1
24 28 34 40 50 60 70
VOLUME l8 20 l6 l4
B
ON
OFF
OFF
l 0 dB
Set to the "
" position.
2
* If you use two speaker systems, press both the A and B switches.
Turn the power on.
POWER
5 6
Play the source.
VOLUME l8 20 24 28 l6 l4 l2 l0 8 6 4 3 2 70 0 dB l
3
34
Select a desired input source.
INPUT CD TAPE 1 TAPE 2 TUNER PHONO
40 50 60
AUX
Adjust to the desired output level.
*
AX-590 only If you select turntable as an input source (PHONO position), you should confirm that the PHONO (MM/MC) switch on the rear panel is set to the position corresponding to the type of cartridge being used by the turntable. (Refer to page 4. )
7
If desired, adjust the BASS, TREBLE, BALANCE and LOUDNESS controls, etc. (Refer to page 910. )
To turn off the power
Press the POWER switch again.
7
AX-590
3 1
AX-490
3, 5 3
1 3, 5
TO RECORD A SOURCE TO TAPE (OR DUB FROM A TAPE TO ANOTHER)
1
Select the source to be recorded. AX-590 AX-490
REC OUT
REC OUT
TAPE 1 TEAP 2 AUX CD TUNER PHONO
4 5
PHONO CD
Set the tape deck to be used for recording in the recording mode.
TAPE 1 TAPE 2 AUX
TUNER
To monitor the sound to be recorded (or being recorded), select the tape deck being used for recording with the INPUT selector.
INPUT CD TAPE 1 TAPE 2 TUNER PHONO
2 3
Play the source.
AUX
Confirm the source by selecting it with the INPUT selector and turning up the VOLUME control.
VOLUME
INPUT
20
l8 24
l6
l4 l2 l0 8 6 4 3 2
CD TAPE 1 TAPE 2 TUNER
28
PHONO
34 40
AUX
50 60 70 0 dB l
Notes If you want to enjoy another source while recording, select it with the INPUT selector. q VOLUME, BASS, TREBLE, BALANCE, LOUDNESS controls, CD DIRECT AMP switch and PURE DIRECT switch settings have no effect on the material being recorded.
q
8
Adjusting the BALANCE control
Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused from speaker location or listening room conditions. AX-590 AX-490
Selecting the SPEAKER system
Because one or two speaker systems can be connected to this unit, the SPEAKERS switches allow you to select speaker system A or B, or both at once.
SPEAKERS
BALANCE
A
ON
B
ON
BALANCE
l 2 3 4 L5 5R 0 l 2
l 2
0
l 2
OFF
3 4
3 4 L5
3 4 5R
OFF
Adjusting the BASS and TREBLE controls
AX-590
BASS
l 2 3 4 5 5 0 l 2 3 4 2 3 4 5 5 4
Adjusting the continuously variable LOUDNESS control
This control provides compensation for the human ears' loss of sensitivity to high and low-frequency ranges at low volume. This control is adjustable to retain full tonal range at any volume level.
TREBLE
l 0 l 2 3
1
AX-590
LOUDNESS
l FLAT
30 dB
AX-490
LOUDNESS
AX-490
BASS l 2 3 4 5 5 0 l 2 3 4 2 3 4 5 5 TREBLE l 0 l 2 3 4
l
l0 9
FLAT
30 dB
Set to the "FLAT" position.
l0 9
2 3 4 5 6 7
2 3 4 5 6 7
8
8
2
20 24 28 34
VOLUME l8 l6 l4 l2 l0 8 6 4 3 2 70 0 dB l
BASS
: Turn this clockwise to increase (or counterclockwise to decrease) the low frequency response.
TREBLE : Turn this clockwise to increase (or counterclockwise to decrease) the high frequency response.
40 50 60
Set to the loudest listening level that you would listen to.
3
AX-590
AX-490
LOUDNESS
LOUDNESS
l 2 3 4 5 6 7 FLAT
30 dB
Turn until the desired volume is gained.
l
l0 9 8
FLAT
30 dB
2 3 4 5 6 7
l0 9 8
9
Using the PURE DIRECT switch
You can enjoy the purest possible sound from your audio sources by setting this switch so that the indicator illuminates. By doing so, the audio signals bypass the BASS, TREBLE, BALANCE and LOUDNESS controls, thus eliminating any alterations to the audio signals. AX-590 only * The SUBSONIC FILTER switch and the PRE OUT/MAIN IN terminals are also bypassed.
Using the CD DIRECT AMP switch
You can enjoy the purest possible CD sound from your CD player by setting this switch so that the indicator illuminates. By doing so, CD's input signals are sent to the built-in amplifier special for CD directly bypassing the INPUT selector, BASS, TREBLE, BALANCE and LOUDNESS controls, and then sent to the power amplifier. This signal routing reproduces the purest CD sound eliminating any alterations to the CD signals. [. . . ] 76 dB CD/TUNER/TAPE/AUX (Input Shorted) (CD DIRECT AMP; ON) . . . . . . . . . . . . . . . . . 110 dB
<AX-590>
8 ohms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 145W 6 ohms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 170W
<AX-490>
8 ohms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 130W 6 ohms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150W Input Sensitivity/Impedance PHONO MM . . . . . . . . . . . . . . . . . . . . . 2. 5 mV/47 k-ohms PHONO MC <AX-590 only> . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 160 µV/220 ohms CD/TUNER/TAPE/AUX . . . . 150 mV/47 k-ohms MAIN IN <AX-590 only>. . . . . . 1. 0V/10 k-ohms
<AX-490>
PHONO MM (5 mV Input Shorted) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 88 dB CD/TUNER/TAPE/AUX (Input Shorted) (CD DIRECT AMP; ON) . . . . . . . . . . . . . . . . . 110 dB Residual Noise (IHF-A Network) (CD DIRECT AMP; ON). . . . . . . . . . . . . . . . . . . . . . . 35 µV (PURE DIRECT; ON). . . . . . . . . . . . . . . . . . . . . . . . . . . 90 µV
<AX-590> . . . . . . . . . . . . . . . . 10. 4 kg (22 lbs. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE YAMAHA AX-490
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual YAMAHA AX-490 will begin.