User manual ZANUSSI Z18/8R3

[. . . ] Nevertheless, should any problem arise during usage, whether it be during the warranty period, or when such period has expired, please directly contact your nearest Zanussi Service Centre. The address and telephone number of said Centre can be easily found in the enclosed List or by looking in the telephone directory, under Zanussi. Our Zanussi Service Network is at your complete disposal, to serve you with maximum speed and efficiency, all you have to do is call. The products In order to obtain a good wash, it is necessary to use detergents specially designed for dishwashers. To ensure that your dishwasher functions perfectly, Zanussi recommends using Calgonit System, a unique and complete product, tested by millions of householders. [. . . ] Top up the rinse aid when the indicator (B) becomes clear. BR01 A Ensure that the lid is closed after every refill. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 minimum dosage, position 6 maximum dosage). Gradually increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes. BR02 B m a x 6543 21 BR03 C x m a 6543 21 31 PFR01GB Use of detergent Only use detergents specifically designed for use in dishwashers. To fill the dishwasher with detergent proceed as follows: Open the dispenser lid by pulling the catch (D). Add the detergent according to the recommendations in the programme chart. As all detergents are not the same, you should also consult the instructions on the packet specially for tablets. To help correctly dose the right amount of detergent, inside the container there are two reference marks: - MIN = 15 ml - MAX = 30 ml Always close the lid. If the programme has a prewash add the required detergent over the lid of the dispenser. Insufficient quantities of detergent will produce poor washing results, whereas an excessive amounts of detergent will not improve washing results and is also wasteful. Check the filters Ensure they are clean and properly positioned (see cleaning instructions). 9. Start the programme Depress the On/Off button. If you wish to interrupt the wash programme at any time press the button again. To restart the machine, depress the same button again and the programme will continue from the point where it was interrupted. 2. Check that there is rinse aid and salt Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. At the end of the washing programme At the end of the washing programme the machine stops automatically. The On/Off indicator light remains on until the On/Off button is depressed. 4. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the Programme chart and close the lid. 5. 11. Switch off the dishwasher Switch off the dishwasher by pressing the On/Off button and open the door. When the wash programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working;if the door is opened however, a safety device ensures that the machine stops. [. . . ] If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. 42 PTS01GB Adjusting the worktop You can move the worktop forward or backward by 25 mm in order to align the machine with other kitchen units. Simply unscrew the two rear retaining screws, move the top to the required position and then retighten the screws. Fitting Under a Counter (kitchen worktop or sink) By removing the machine's worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture. IN26 570÷ 600 Proceed as follows: Remove the machine's worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop. Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. IN05 600 Fitting a decor panel on the door The door of this machine has frames for fitting a plastic laminate decor panel in the colour required to match the dishwasher with the rest of the kitchen furniture. [. . . ]