User manual ZANUSSI ZANS730

[. . . ] The items you place on the hob could easily catch fire when turning on the hob accidentally. Never leave the hob unattended when working with oil and fats because of the danger of fire. Sugar (solid or liquid) should never get onto the hot surface of the hob. They melt at high temperatures and can cause fissures and cracks when the hob cools down. [. . . ] Use only pans with flat bases without rough edges to avoid remaining scratches. If any cracks appear on the hob surface, the hob has to be switched off immediately. Disconnect the appliance from the mains and inform the service department. A defective hob surface allows overboiling food to penetrate and the contact with live parts. ZANUSSI declines any liability should the appliance be used improperly and the safety measures not be observed. Keep these operating and assembly instructions! Unpacking and control Please examine the appliance for any damage sustained during transportation!If the appliance is damaged please immediately inform the forwarding company before the appliance is connected. The packing material should be disposed properly. Description of the appliance ZGR / ZGRN / ZGRW / ZGRX 2404-07 1) Cooking zone 2) Cooking zone 3) Cooking zone 4) Cooking zone 5) Residual heat indicator 180 mm 145 mm 180 mm 145 mm 1700 W 1200 W 1700 W 1200 W 2 3 1 5 4 Technical data Typ 076. 0 Instr. 941 591 668 5. 8kW hob dimensions: length width height : 572 mm : 502 mm : 44 mm : 560 mm : 490 mm Instr. ZANUSSI cutout dimensions: length width voltage total power Typ 076. 0 Instr. 941 591 670 5. 8kW Rating plates 13 Operating your hob Cooking zones The cooking zones are clearly marked on the ceramic surface. Scrapers are available in craft shops and department stores as well as in decoration stores. Best is to let the detergent dry on the surface and to wipe it off with a damp cloth. If there are remains of cleaning agents wipe them off before you turn on the heat again. ZANUSSI declines any liability should the appliance be used improperly and the safety measures not be observed. 15 Installation Cut out worktop to prescribed measurements of templates (saw exactly along the scribing). Using a standard or Phillips screwdriver, tighten the tension clamps evenly starting at the centre and moving diagonally until the built-in rim is tight on the worktop. Do not use an electric or pneumatic sdrewdriver without an adjustable safety clutch (pos. The installation of the control box or the oven will be carried out according to separate instructions. In order not to damage the appliance, the hob may only be connected to control boxes which are approved by the supplier of the ceramic hob. The distance between the underside of the hob and the furniture underneath must be at least 20 mm (see fig. 2). The electrical connection of the ceramic hob should only be carried out by a trained technician. The protection against accidental contact must be ensured by proper installation. [. . . ] The protection against accidental contact must be ensured by proper installation. Attention: If there are any repairs to be effected, the appliance must be non-tensioned (e. g. As soon as a crack is visible in the top, the appliance has to be disconnected from the mains. In terms of fire protection, the appliance conforms to type Y (IEC 335-2-6). [. . . ]