User manual ZANUSSI ZHC 6244

[. . . ] The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose. Do not install above a cooker with a high level grill. · · Child Safety · The appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. · Never leave frying pans unattended during use as over-heated fats and oils might catch fire. [. . . ] The cooker hood must be kept clean, a build up of grease or fat can be a fire hazard. If you have the cooker hood operating in the re-circulation mode, it is necessary to change the charcoal filters (N) regularly according to use. To remove the charcoal filters: take off the anti-grease grilles as described in the installation section. The 2 anti-grease filters are easily removed from the grille by following the instructions and lifting the two metallic stops (P). If you are using the hood in the re-circulation mode, you will need to remove the charcoal filter to access the anti-grease filters. External Cleaning Any fat deposits should be removed regularly, at least every two months. To clean the outside of the cooker hood, use a cloth dipped in lukewarm water to which a small amount of washing up liquid has been added. To clean the steel, brass or copper parts on the outside of the appliance, use a proprietary cleaner and follow the manufacturer's instructions. The inside of the appliance should be cleaned with a soft cloth or brush dipped in warm soapy water. WARNING: There is a third metallic filter (not visible) which can be accessed through opening R. 5 SOMETHING NOT WORKING If, having carried out these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Symptom The cooker hood will not start Solution Check that the hood is connected to the electricity supply. Technical Information DIMENSIONS Height Width Depth Gross weight Net weight ELECTRICAL SUPPLY: POWER CONSUMPTION: FAN MOTOR: LAMP: SUITABLE FOR INSTALLATION ABOVE: 1410-2340mm 700mm 500mm 23kg 20kg 220-240V (50Hz) 280 W 200 W 80 W 650mm min ­ 750mm max 650mm min ­ 750mm max (2x40W candle) Electric Slot-In Cooker: Gas Slot-In Cooker: NOTE: CE marking certifies that this appliance complies with the requirements laid down in the EEC directive 89:336 (Electromagnetic Compatibility) and subsequent modifications; EEC directive 73/23 (Low Voltage) and any subsequent modifications. ELECTRICAL CONNECTION This appliance must be earthed. Electrical Requirements Any permanent electrical installation must comply with the latest I. E. E. For your own safety this should be undertaken by a qualified electrician e. g. your local Electricity Board, or a contractor who is registered with the National Inspection Council for Electrical Installation Contracting (NICEIC). Electrical Connection Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate of the cooker hood. This appliance conforms to EEC Directive No 78 308 regarding suppression of radio and television. 8 INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installation must comply with the local authorities requirements for the discharge of exhaust air. Installation Requirements Before installation, check that the wall to which the cooker hood is to be fitted for electricity cables and water and gas pipes. This cooker hood is designed to be fixed to any rigid vertical surface over a cooking area, and can be used in the extraction (ducted to the outside) or re-circulation (internal recycling) mode. The installation work must be carried out by a qualified electrician or competent person. The manufacturer declines any responsibility for damages due to incorrect installation of the cooker hood or if the cooker hood is not installed in compliance with relevant regulations controlling this type of installation. [. . . ] To remove the first grille, push it towards the rear of the apparatus by using the finger points so that it is released (fig. 3). To take it off completely, rotate it on one side while keeping the other one steady. 3 Wall Fitting Fix the telescopic part (A) with some adhesive tape (W) so that it cannot slip out (fig. Fix the lower part to the upper part of the hood by using the screws supplied (fig. [. . . ]