User manual ZANUSSI ZHC7141

[. . . ] · If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room. · The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose. · Do not install above a cooker with a high level grill. Child Safety · This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. During Use · This product is for domestic use only. [. . . ] The charcoal filters cannot be cleaned, we recommend they should be replaced approximately every three months or more often if the hood is used for more than three hours per day. To Remove/Replace the Charcoal Filters 1. Place the filter over the inlet grille at either end of the fan housing and rotate clockwise (B) into position. This appliance can be a possible fire hazard if the grease and charcoal filters are not cleaned and replaced as recommended. B 3. A 4. Changing the Light Bulb 1. To replace the light bulb insert a replacement into the holder then rotate the bulb clockwise into position. Replace the lamp cover. 3. 4. If the light bulb fails to function check that the bulb is fully screwed into the holder. If bulb failure has occurred then it should be replaced with a 220-240 Volt 40W clear globe shaped bulb with a small E14 screw thread. Replacement filters and light bulbs can be obtained from your local Service Force Centre. 7 SOMETHING NOT WORKING If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Symptom The cooker hood will not start Solution · Check the hood is connected to the electricity supply. · The fan speed is set high enough for the task · The grease filter is clean. · The kitchen is adequately vented to allow the entry of fresh air. · If set up for recirculation, check that the charcoal filter is still effective. · If set up for extraction, check that the ducting and outlets are not blocked. For your own safety this should be undertaken by a qualified electrician e. g. your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC). This appliance is fitted with a 3 core mains cable and must be permanently connected to the electricity supply via a double-pole switch having 3mm minimum contact gap on each pole. If the output of the appliance below the cooker hood exceeds the maximum outputs quoted, please refer to the cooker manufacturer's installation instructions. A clearance height of 650mm (25 1/2 ") is required when installed above a built-in electric hob, or 700mm (27 1/2 ") when installed above a built-in gas hob. A clearance height of 685mm (27") is required when installed above a slot-in electric cooker, or 787mm (30 1/2 ") when installed above a slot-in gas cooker. When installed between adjoining wall cabinets, the wall cabinets must not overhang the hob and the distance between the underside of the cabinet and the worktop must be 450mm. If the height of the wall cabinet is less than 450mm, a gap of 50mm must be maintained either side of the hob. This cooker hood must not be installed above a cooking appliance with a high level grill. The hood can be installed above these heights but for optimum performance it should be installed at the distances quoted for the appropriate heat source. This appliance can be used in either extraction mode (ducting) or recycling mode (filtering). The hood is supplied suitable for recirculation with the charcoal filters fitted. [. . . ] When the cooker hood is ducted to the outside the charcoal filter must be removed. Fitting the Ducting · Fit the ø150mm (6ins) ducting to the spigot on top of the hood body as illustrated. · When using ø125mm (5ins) ducting fit item 9 and 10 on to the spigot on the top of the hood body as illustrated. · For the best performance use the shortest possible run of ducting and we recommend the use of rigid pipe in preference to flexible hose as this will improve the flow of air while reducing turbulence, which causes causes noise and a loss of performance. · If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler, then its flue must be be of the room sealed or balanced flue type. [. . . ]