User manual ZANUSSI ZKI525

[. . . ] User Manual Washerdryer Centrifugeren Centrifugeren Pompen Spoelen Inweken Inweken 30° Gordijnen Gordijnen 40° Sport Spor t 40° intensief Wol 40° Handwas Handwas 30° Handwas Handwas 40° 95° 60° eco 60° 40° 30° 60° 40° 30° 30° Anti-kreuk 40° 40° Anti-kreuk ZKI 525 Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel and functions - - - - - - - - - - - -6 Programme table - - - - - - - - - - - - - - - - - -10 Programme information - - - - - - - - - - - - - -12 Washing hints - - - - - - - - - - - - - - - - - - - - -13 Drying hints - - - - - - - - - - - - - - - - - - - - - -15 Before the first use - - - - - - - - - - - - - - - - -16 Operating sequence - - - - - - - - - - - - - - - -17 Time drying - - - - - - - - - - - - - - - - - - - - - - -21 Care and cleaning - - - - - - - - - - - - - - - - - -22 What to do if. . . [. . . ] Select the desired option by pressing buttons 3, 4, 5 and 6 Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before depressing the button 8. For the compatibility of the options with the washing programmes, refer to the section «Programmes table». Start the programme by pressing button 8 To start the selected programme, press this button; the corresponding green pilot light stops flashing. The pilot light 9 illuminates to indicate that the appliance starts operating and the door is locked. If an option which is not compatible with the set wash programme is selected, the message Err is displayed for a few seconds and the red light of this button flashes for 3 times. Select the delayed start by pressing the button 10 Press this button to select the required delay. The selected delay time value will appear on the display for a few seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you press the button 8. You can cancel the delay time at any moment, before you press button 8. If you have already pressed it, and you wish to CANCEL the delay time, proceed as follows: · set the washing machine to PAUSE by pressing button 8; · press the button 10 once. · The selected delay can be modified only after you have turned the programme selector dial to the «O» position and after you have selected the programme again. If you need to open the door, you must first set the washing machine to PAUSE by pressing button 8. The door can be opened immediately or after a few minutes depending on the model. The Delay Start cannot be selected with «Drain» programme. Altering an option or a running programme It is possible to change some option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing button 8. Turn the programme selector dial to «O» and then to the new programme position. Interrupting a programme Press button 8 to interrupt a programme which is running, the corresponding light starts to flash. Cancelling a programme Turn the selector dial to «O» to cancel a programme which is running. Opening the door after the programme has started First set the machine to pause by pressing the button 8. If the light 9 goes off, the door can be opened immediately or after a few minutes depending on the model. If it does not switch off, this means that the machine is already heating, that the water level is too high. [. . . ] NOTE Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. Building-in This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A. 600 600 in. 515 596 600 m 416 818 120 541 8 160 When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the two recesses on the back of the appliance. Preparation and assembly of the door The machine is originally pre-arranged for the assembly of a door opening from right to left. In this case it is sufficient to screw in the hinges (1) and the counter-magnet (6) provided with the appliance, at the right level (Fig. [. . . ]