User manual ZANUSSI ZT1012

[. . . ] WASHING MACHINE ZT 1012 TEMPERATURES PROGRAMMES ON-OFF QUICK WASH AQUACYCLE ZT 1012 Quick Installation Guide: visit our WEB SITE to view an install video www. video. uk. electrolux. com 132985620 INSTRUCTION BOOKLET GB Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. You MUST read them carefully before installing or using the appliance. Installation This appliance is heavy. It is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] This will help to prevent the formation of lime deposits. P0010 P0009 Cleaning the drawer recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme without any clothes in the drum. After each wash Leave the door open for a while. This helps to prevent mould and stagnant smells forming inside the appliance. Keeping the door open after a wash will also help to preserve the door seal. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. Use a normal measure of detergent, must be a powder (such as Ariel Futur). P0038 Cleaning the filter The water drain filter A clean filter is important for the correct operating of the machine, and should therefore be cleaned after every washing programme. If the filter is blocked and the machine is unable to drain you will need to drain the water manually from the machine at this stage. To do this, unhook the drain hose from the standpipe or sink and hold the end of the hose over a bowl on the floor. Repeat the procedure until water stops flowing out. External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. Remove the drawer by pressing the catch downwards and by pulling it out. To aid cleaning, the top part of the additive compartment should be removed. P0037 16 Unscrew and remove the filter. Clean carefully under a fast running tap. The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in a bowl. When you intend to start the machine up again, make sure that the room temperature is above 0°C. P0039 P0040 Warning When the appliance is in use and depending on the programme selected there can be hot water in the filter. Never remove the filter during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the filter, ensure it is securely retightened so as to stop leaks and young children being able to remove it. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: pull out the plug from the power socket; close the water tap; if necessary, wait until the water has cooled down; Unscrew and remove the filter; place a bowl on the floor. Repeat the procedure until water stops flowing out; clean the filter if necessary as previously described; screw the filter again. The water inlet filter Ifyour water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. Tighten up the inlet hose. P1090 17 Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom The machine does not start Possible causes The door has not been closed. There is no supply at the socket The main fuse or the fuse in the plug has blown. The wash load is unbalanced: redistribute the clothes inside the drum to allow the machine to spin. Too much detergent or unsuitable detergent has been used (creates too much foam). [. . . ] B). 6 4 195 C b) Hinges To mount the hinges it is necessary to drill two holes (dia. 35 mm, depth 12. 5-14 mm depending on the depth of door furniture) on the inner side of the door. The distance (B) from upper edge of the door to the centre of the hole depends on the adjacent furniture's dimensions. The hinges will be fixed to the door by means of screws for wood (2-Fig. [. . . ]