User manual ZANUSSI ZW6040IE

[. . . ] If you sell your washing machine or give it away, make sure that it is accompanied by its user's manual. The new user can then be informed of how the washing machine operates and read relevant warnings. These warnings have been written for your safety and for the safety of others. Please read these comments carefully before installing and using your washing machine. [. . . ] «Quick wash» pushbutton If you select this function, the wash time is reduced depending on which program you chose. 3. 5. 4. «Prewash» pushbutton The washing machine does a prewash at 30°C maximum. The prewash finishes with a brief spinning for cotton and synthetic programs, and by a draining for delicates programs. 3. 6. Starting the programme After you chose the washing programme, press the Start/Pause pushbutton to start the cycle. It is normal that the programme selector does not turn during the cycle. * depending on model 5 When the cycle begins, the status of cycle is displayed by the corresponding led. 3. 7. Adding of laundry Press the Start/Pause pushbutton : the corresponding light flashes as long as the programme is paused. You will then hear a double "click" in the locking device when the cover opens. For reasons of safety, you cannot open the cover if the temperature of the washing water is too high. 3. 7. 2. Modifying the current programme Before modifying the options of the current programme, you must put the washing machine to pause by pressing on the «Start/Pause» pushbutton. If it is impossible to make the modification, the corresponding light flashes for few seconds. If you decide to change the programme in any case, you will need to cancel the current programme (see below). 3. 7. 3. Respect the proportion and frequency of descaling shown on your packaging. 6. 2. The surface Clean the surface of your washing machine using lukewarm water and a mild detergent. Turn the cap in the anti-clockwise direction until it is vertical to release residual water. 6. 3. The detergents dispenser From time to time, you must clean the detergents dispenser in order to eliminate the possible wastes of the detergents and then to avoid an operating problem. The detergent dispenser is very easy to remove for a light cleaning. Disassembly: Press the clips on each side of the detergents dispenser and pull it upwards. · Remove the filter: Unscrew the cap all the way and take it off. Put the assembly back and screw it in the clockwise direction. You can thus clean it using running water and a brush or a twisted cloth. Check that the siphons at the back of the detergents dispenser are not blocked. After cleaning the filter, you are required to closed the door. In fact, for reasons of safety, the door must be closed when the appliance is working. Reassembly : Put the detergents dispenser in the notches until they lock. *depending on model 10 7. OPERATING PROBLEMS Many checks have been carried out during the manufacture of your washing machine. However, if you face a problem with its operation, please read the following sections before calling the After Sales service. [. . . ] After installing your washing machine, make sure that it is not standing on its electrical power supply cable. When your machine is installed on a carpeted floor, make sure that the carpet does not close off the ventilation openings near the bottom of the machine. The power supply cable may be only replaced by the After Sales Service. Your manufacturer cannot be held responsible for any damage resulting from a nonconform installation. · · · · · 2. [. . . ]