User manual ZANUSSI ZWC6050W

[. . . ] User Manual Washing machine ZWC 6050 W ZWC 7050 W Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel - - - - - - - - - - - - - - - - - - - - - -6 Functions - - - - - - - - - - - - - - - - - - - - - - - - -7 Programme table - - - - - - - - - - - - - - - - - - -9 Programme information - - - - - - - - - - - - - -11 Washing Hints - - - - - - - - - - - - - - - - - - - - -12 Before the first use - - - - - - - - - - - - - - - - -14 Operating Sequence - - - - - - - - - - - - - - - -15 Care and cleaning - - - - - - - - - - - - - - - - - -18 What to do if. . . [. . . ] If you need to open the door, you must first set the washing machine to PAUSE by pressing button 5 and wait some minutes till the pilot light 7. 2 goes off. The Delay Start cannot be selected with «Drain» programme. Start the programme by pressing button 5 To start the selected programme, press this button; the corresponding green pilot light stops blinking. The pilot light 7. 1 is on to indicate that the appliance starts operating. If you have chosen a delayed start, the machine will begin the countdown. Altering an option or a running programme It is possible to change some options before the programme carries it out. Before you make any change, you must pause the washing machine by pressing button 5. Turn the programme selector dial to «O» and then to the new programme position. Interrupting a programme Depress the button 5 to interrupt a programme which is running, the corresponding light starts blinking. Cancelling a programme Turn the selector dial to «O» to cancel a programme which is running. Opening the door after the programme has started First set the machine to pause by pressing the button 5. If it does not switch off, this means that the machine is already heating, that the water level is above the bottom edge of the door. If you cannot open the door but you need to 16 open it you have to switch the machine off by turning the selector dial to «O». After few minutes the door can be opened (Pay attention to the water level and temperature!). After closing the door, it is necessary to set the programme and the options again and then to press button 5. At the end of the programme The machine stops automatically, the pilot light of button 5, the pilot lights 7. 1 and 7. 2 go off and the pilot light 7. 3 goes on. If a programme or an option that ends with water still in the tub has been selected, the pilot light 7. 2 remains lit, the pilot light of button 5 goes off and the door remains locked to indicate that the water must be emptied out before opening the door. select the «Draining»or «Spinning» programme 3. when the programme has finished the pilot light 7. 2 goes off and the door can be opened. At the end of the cycle, turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. Leave the door open to prevent the formation of mildew and unpleasant smells. 17 Care and cleaning IMPORTANT!You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. [. . . ] This branch must be above the trap so that the bend is at least 60 cm above the ground. Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. For a correct functioning of the machine the drain hose must remain hooked on the proper support piece situated on the top part of the back side of the appliance. [. . . ]