User manual ZIBRO D116

[. . . ] The automatic delay protects the compressor. IMPORTANT The device MUST always have an earthed connection. Read these instructions carefully and follow the instructions. Before connecting the unit, check the following: The voltage supply must correspond with the mains voltage stated on the rating label. The socket and power supply must be suitable for the current stated on the rating label. The device must be placed on a flat and stable surface. The electricity supply to the device must be checked by a recognised professional if you have any doubts regarding the compatibility. [. . . ] The display indicates the set humidity (SET HUMIDITY) and also the relative humidity (ROOM HUMIDITY). The device starts to dehumidify when the relative humidity in the room is higher than the set value. The device switches off automatically when the set value is reached, and restarts when the humidity in the room rises again. You can select two settings: The timer function enables you to switch the device off after a certain time. The operating time can be set between 1 and 12 hours with the -button. Every time you press the button, the running time is extended by 1 hour. When the pre-set time has elapsed, the device will switch off. 6 The dehumidifier DX118 is equipped with a heating function. By pressing the turned off. button to button again, the heating function will be 7 Press the -button to turn the device off. 4 56 AIR FILTER The D112, D116 and DX118 dehumidifiers are equipped with a 3-layer filter package to clean the circulated room air. The filters are delivered with a separately packed 3MTM HAF filter and an active carbon filter. These filters must be placed according to instructions before operating the dehumidifiers. 3MTM HAF filter; to remove unhealthy particles from the air such as pollen, bacteria, animal dander and dust. 3 Active carbon filter sheet; to remove odours. The filter holder on the backside of the unit can be opened. 1 The screen filter has to be cleaned regularly with a vacuum cleaner to avoid blocking of the air flow. 2 The positive/negative electro statically charged 3MTM HAF filter is recommended to be changed every 3 months. Unusual dirt, construction work, pets, the presence of smokers and running the dehumidifier unit continuously can shorten the life time of the 3MTM HAF filter. New filter Recommended change of filter 3 The active carbon sheet can be cleaned with a vacuum cleaner when dusty but has to be changed at the same time as the 3MTM HAF filter. NOTE! Never use the dehumidifier without the screen filter! To run the unit without active carbon sheet and/or 3MTM HAF filter package does not bring any harm to the dehumidifier. Replacement filters are available at your dealer. WATER DRAINAGE When the water container is full, the will restart. -light switches on and the dehumidifier switches off automatically. The device 4 57 If desired, it is possible to connect a drainage hose to the device for permanent water drainage. Connect the drainage hose and ensure that the end of the hose is lower than the spout, otherwise the water will not drain and flooding may occur. [. . . ] The warranty will expire if any alterations have been made, not genuine components have been fitted or if the dehumidifier has been repaired by a third party. Components subject to normal wear and tear, such as the air filter, are not covered by the warranty. The warranty is only valid on presentation of the original, unaltered, and datestamped purchase receipt. The warranty does not cover damage caused by actions that deviate from those as described in the user's manual or by neglect. 4 59 Transportation costs and the risks involved during the transportation of the dehumidifier or components shall always be for the account of the purchaser. To prevent unnecessary expenses, we recommend that you always carefully read the user's manual first. [. . . ]