User manual ZIBRO D2010

[. . . ] The shelf can be attached to the dehumidifier by placing the shelf's two feet in the top slot of the grille on the air outlet. Smaller items of clothing placed on or hung down from the shelf can be dried using the hot air from the air outlet. The shelf is removed by pressing it out sideways from the dehumidifier. Acoustic and visual warning signal when the built-in water tank is full. [. . . ] the air dehumidifier is suitable for dehumidifying a room of up to 75m2. However, this depends on the ambient temperature and the relative humidity. the effect of the air dehumidifier is higher at a combination of high temperature and high air humidity. A relative humidity of around 50% and below is recommended for living areas. FUNCTIONS The appliance can run in either "Stand-Alone Mode", where all humidity is removed from the surrounding air and collected in the built-in water tank in the appliance, or "Continuous Draining Mode", where the water is removed from the air and led to an external drain via the built-in outflow using the attached plastic hose. STAND-ALONE MODE Here, the rubber plug is placed in the outlet pipe on the back of the appliance, and all humidity is removed from the air and collected in the built-in water tank. When the tank is full, the light on the control panel comes on , the appliance switches off and also emits a short beep to show that the water tank is full. When the empty tank is replaced, the dehumidifier starts again automatically. CONTINUOUS DRAINING MODE Here, the rubber plug is removed from the outflow pipe on the back of the appliance and one end of the accompanying transparent, flexible plastic pipe is pushed over the outflow pipe. (The rubber plug can be pushed over the protruding tap above the outflow pipe to avoid it getting lost). The other end of the plastic pipe is led downwards to a place where the humidity can drain away continuously. As a result, water does not collect in the built-in tank, and the visual and acoustic signals indicating that the built-in water tank is full do not function. fULL WATER TANK Using the "Stand-Alone" function , humidity is removed from the air and collected in the built-in water tank. When the tank is full, the light on the control panel comes on, the appliance switches off and also emits a short beep to show that the water tank is full. Once the empty tank is replaced, the dehumidifier starts again automatically. The current room temperature and air humidity are shown in the electronic display. Press "ON/OFF" once: The appliance shuts down when the relative humidity is lower than 40% 3. Press "ON/OFF" twice: The appliance shuts down when the relative humidity is lower than 50% 4. Press "ON/OFF" three times: The appliance shuts down when the relative humidity is lower than 60% 5. Press "ON/OFF" four times: The appliance shuts down when the relative humidity is lower than 70% 6. Press "ON/OFF" five times: HIGH speed (maximum) dehumidification level is activated. The current room temperature and air humidity are shown in the electronic display. [. . . ] In case of replacement, the colour and model can be different from that of the original purchased unit. the initial purchase date shall determine the start of the warranty period. The warranty period is not extended if the unit is replaced or repaired by PVG or its officially appointed service centre. DISCLAIMER OF WARRANTY Damage or defects caused by incorrect treatment or operation and damage resulting from the use of nonoriginal parts or accessories not recommended by PVG are not covered by the warranty. [. . . ]