User manual ZIBRO PX 150

[. . . ] ¶ º ¾ Exhaust air outlet Air inlet Power cable compartment µ ¸ ¹ Power cord Cord hanger Connection box Active carbon filter Bracket fro mounting outdoor unit Spanners Spacer, screws, protection caps Remote controller Congratulations on the purchase of your Zibro Clima air conditioner. In addition to air cooling, this air conditioner has two other functions, namely air dehumidification and circulation. the mobile Zibro Clima air conditioner is extremely easy to operate and move. You have acquired a high quality product that will provide you with many years of pleasure, on condition that you use it responsibly. [. . . ] Close the fireplace damper and floor and wall grills so that cool air does not escape through the chimney or ductwork. Set the unit to maximum cooling and high-speed fan initially, then adjust the unit to a comfortable setting. The unit selects the mode depending on the room temperature: higher than 23°C, cooling mode; between 20°C and 23°C, fan mode. 5 Temperature selection Set the temperature that must be maintained (in the range from 16°C to 30°C) with switched 6 Digital display When the unit is ON the display shows the room temperature ( or to see the set temperature ( room temperature will again be displayed. 7 `SLEEP' setting This setting can only be used when the cooling function is activated. Every hour the temperature setpoint will raise with 1°C, after 2 hours the temperature remains the same. Remote control The air conditioner can be operated with remote control. The compressor has been set so that it starts functioning three minutes after the (re)start of the air conditioner. The cooling will switch off when the room temperature is lower than the set one. When the room temperature rises above the selected value, the cooling will work again. While using the heating function during low temperatures, heating will occasionally stop for a while in order to melt the internal frost. The condensed water will be discharged from the hole placed at the back of the indoor unit. If the indoor unit needs to be disconnected from the outdoor unit, to place it in a more suitable position, follow these steps: Disconnecting 1 Open the tube connection box (12) situated at the back of the indoor unit. The terminals are fitted with automatic self-sealing valves to prevent the gas from leaking. During the operation take extreme care not to break the refrigerant tubes. 5 Cap the terminals with the caps (16) provided to protect them from dust. 3 Reconnect the refrigerant tubes (tighten the nuts quickly to make a good seal), the drain tube and the electrical cable. Never use aggressive chemicals, petrol, detergents or other cleansing solutions. [. . . ] 7 Transportation costs and the risks involved during the transportation of the air conditioner or air conditioner components shall always be for the account of the purchaser. To prevent unnecessary expense, we recommend that you always first carefully consult the instructions for use. Take the air conditioner to your dealer for repairs if these instructions do not provide a solution. To be used as indication, subject to modifications ** Room size Compressor model Refrigerant Thermostat range Fan speeds Noise level indoor unit Noise level outdoor unit Length flexible tube Dimensions indoor unit (b x d x h) Dimensions outdoor unit (b x d x h) Weight indoor unit Weight outdoor unit Unit protection indoor unit Unit protection outdoor unit dB dB mm mm mm kg kg gr °C W W A V / Hz m3/h L/24h m3 This data may vary for technical reasons; for greater precision, please refer to the rating label placed at the back of the unit. [. . . ]