User manual ZIBRO R18E

[. . . ] R 18 E 3 2 5 4 > 1 MANUEL D'UTILISATION GEBRAUCHSANWEISUNG INSTRUCCIONES DE USO OPERATING MANUAL ISTRUZIONI D'USO GEBRUIKSAANWIJZING 2 14 26 38 50 62 Dear Sir, Madam, Congratulations on your purchase of this Zibro heater, the number one brand amongst portable heaters. You have purchased a first-class quality product, which will serve you for many years to come. Please read these Directions for Use first, to ensure the maximum lifetime for your Zibro heater. This appliance comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort from your Zibro heater. Yours sincerely, PVG International b. v. [. . . ] Follow the same procedure when you have completely burnt up all fuel from the tank, and after the glass fibre wick has been replaced. Before igniting the heater, always check the fuel indicator to see whether the removable tank needs filling up. Follow the procedure below: 1 Turn the knurled wick adjustment knob clockwise to its stop (Fig. If you J K apply more pressure you may turn it slightly further; however, it will automatically return to the startposition. When you have set the wick to its highest position, this action will automatically activate the safety device. Release the ignition button as soon as a flame is visible in the combustion chamber . When you have ignited the heater but it shuts off again shortly after, the batteries need to be replaced. If the heater has been used only a few times and the wick adjustment knob is not locked, first turn the wick adjustment knob (Fig. L) completely left, before putting the wick in the highest position for ignition (Section C). 4 42 E After having ignited the heater, always check whether the combustion D chamber is level, by sliding it slightly to the left and the right by its handle (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. BURNING OF THE HEATER After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. P). Q VENT. If the flame remains low after the adjustment, the wick height must be adjusted (refer to Section F). Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section L) When there is insufficient ventilation in the room, an intermittent buzzer will be heard and the VENT lamp (Yellow) will be lit (Fig. When this signal is given, ensure that the ventilation of the room is improved (e. g. by opening a door or window a little more) to avoid that the heater shuts off. When the ventilation of the room is improved, the VENT lamp and buzzer will be deactivated. When there is still insufficient ventilation, the heater shuts off automatically. by opening a door or window a little more), the heater can be ignited again. This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. L E F SWITCHING OFF THE HEATER Push the OFF-button . L). MALFUNCTION, CAUSES AND SOLUTIONS If any malfunctioning cannot be solved from the directions below, please contact your dealer. [. . . ] Position the front of the heater at a minimum distance of 1. 5 metres from walls, curtains, and furniture. Make sure that the fuel is not exposed to heat or extreme temperature changes. Always store the fuel in a cool, dry and dark place (sunlight will affect the quality). Never use the heater in places where harmful gasses or fumes may be present (e. g. [. . . ]