User manual ZIBRO R50C

[. . . ] Only use Class C1 paraffin fuel in accordance with BS2869: Part 2, or equivalent. Your heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Extra or Zibro Kristal. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. This cover allows you to keep your hands clean when opening the fuel tank. [. . . ] Either of the two keys to switch on the function (the CLOCK light and the information display ¹ will start blinking). Next, set the hours using the key on the left ( hour) and the minutes using the key on the right ( min. When you hold down the key, the value will F: When the CLOCK indicator light stops blinking, the setting has been locked to the indicated value. After approximately 10 seconds the blinking will stop and the setting will be locked. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. When the heater has been unplugged for more than 10 minutes (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Switch off the function by pressing the SAVE key once Without the 'SAVE' setting your heater will maintain the set temperature by approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. When the FUEL indicator light lights up, there is enough fuel left for another 10 minutes of heater use. The count-down of the remaining heating time can be seen in the information display ¹ (Fig. Every two minutes an alarm signal is sounded, warning you to refill the removable tank. The FUEL indicator light will blink, while four lines are blinking in the You can stop this by pressing the Once the heater has used up all its fuel and extinguished, it will take some time, after the refill, before the heater is completely ready for use again. K: When the FUEL indicator light is lit, the information display will show the number of minutes of fuel left in the tank. When the VENT indicator light starts blinking, this is a sign that the room is not vented sufficiently (Fig. If you do not provide additional ventilation, the heater will switch off automatically after some time. [. . . ] Within this period all defects in material or workmanship will be repaired without any charge. The following provisions shall apply regarding this warranty: 2 Any repairs or replacements of components within the term of warranty will not result in an extension of the term of warranty. 3 The warranty shall no longer apply, when the heater has been modified, non-original parts have been used, or when it is repaired by third parties. 4 The warranty shall not apply to parts that are subject to normal wear, such as the burner mat and the manual fuel pump. [. . . ]