User manual ZIBRO RS145E

[. . . ] If a particular room is smaller than the specified space, always leave a window or door slightly ajar (± 2. We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your heater. Only use Class C1 paraffin fuel in accordance with BS2869 Part two, or equivalent. [. . . ] Release the ignition button as soon as a flame is visible in the combustion chamber ¿. After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle ´ (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The burning can be set up with the flame regulator · If the flame remains low after the adjustment, the wick height must be adjusted (refer to Section G). Too low a flame may also be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section O) Let the heater burn at its lowest setting (Fig. Then slowly turn the flame regulator · anti-clockwise to its stop. In case of an emergency, switch off the heater by pushing in the safety button ³ (Fig. If you see a flashing red light in the information display, you should turn off the heater and fill the removable tank. After a period of time the combustion may no longer be high enough (Section D). 3 Take the plastic ring between your thumb and index finger and pull it out. This can be done in one way only - check the rear of the cap for the correct position. If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section J). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick yourself (see chapter O). To avoid odour when igniting the heater, the ventilator should only be turned on when the flame has reached the correct height (Fig. If any malfunctioning cannot be solved from the directions below, please contact your dealer. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Before you refilled the tank, the heater had burnt up almost all the fuel. [. . . ] 8 Squeeze the wick to loosen the three wick pins and remove the wick from the wick holder. Ensure that you are wearing gloves and that you have a container in which to put the old wick. 9 Put the wick holder back into position in such a way that the holes in the wick holder are directly above the inner sides of the recesses in the burner. Push the three wick pins into the wick holder holes, and Therefore also into the recesses inside the burner. [. . . ]